Genuine Headlamp rim less top dimple fitted to late cars from about 1996 on.

The type with a dimple on top is NLA and this was Rovers replacement which is expensive so see our 500929MS or 17H5143 for better options ...

Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls

A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.

TWin point and overseas cars were fitted with headlamps that self-level for when carrying loads. This is the motor in the headlights.

If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.

With a headlamp rim fixing bracket 37H7421 attached

Whether you are ...

Headlamp sundries kit.

Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.

This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.

Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.

NOW N.L.A was the lamp only less wiring.Fitted as original equipment check whether you have spot or fogs-standard on injection cars.

(number on lens 048025 )

150mm diameter with lugs at top and botton which means it will not fit our...