BOOT BOARD SIDE SUPPORT BRACKET FOR 7.5 GALLON TAN...
14A9784

($6.08) £6.08 exc vat

($7.30) £7.30 inc vat

In stockIn stock
L/H BOOT BOARD SIDE BRACKET FOR 7.5 GALLON TANK.

($6.08) £6.08 exc vat

($7.30) £7.30 inc vat

In stockIn stock

Recommended usage 1 x 14A9784 to fit one mini.
Boot Floor - Qty 1

Recommended products

When a boot board is fitted the following brackets are required:

14A9780 x 2 U shaped for the rear to hold the board.

14A9781 x 2 side bracket with plug for board to sit on except elf/hornet.

[link...

When a boot board is fitted the following brackets are required

14A9780x2 U shaped for the rear to hold the board

14A9781x2 side bracket with plug for board to sit on except elf/hornet

14A9782x1 centre bracket with support ...

The special pointed shape buffer locates against the boot board of Cooper S and variants where a factory type boot board is fitted.

The bracket fitted to the boot board and is not in any kits.

When a boot board is fitted the following brackets are required

14A9780x2 U shaped for the rear to hold the board

14A9781x2 side bracket with plug for board to si...

Kit products

This kit contains all the brackets and mounts required for fitting Minis with 10/12" wheels or with 145 profile tyres.

The boot board bracket 14A9783 is not included

For 10" wheels with 145 tyres and 5.5 gallon tank se...

People also bought products

bracket for boot board R/H on 7.7 gallon tank and on both sides for 5.5 gallon tank when 165 tyres fitted

L/H BOOT BOARD BRACKET FOR 7.5 GALLON TANK AND 165 TYRES.

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

For 7.5 gallon petrol tank cars this is 29" wide with one corner cut. If you are looking for an alternative to this carpet covered wood boot floor, try our plastic load liner EBF100150

This kit contains all the floor brackets and mounts required for fitting Minis with 7.5 gallon tank 10/12" wheels or with 165 profile tyres.

The boot board bracket 14A9783 is not included

For 10" wheels with 145 tyres ...

Taller centre boot board bracket for when wider 165 tyres are fitted to the spare wheel. Supplied with the rubber and pin.

This kit contains all the brackets and mounts required for fitting Minis with 10/12" wheels or with 145 profile tyres.

The boot board bracket 14A9783 is not included

For 10" wheels with 145 tyres and 5.5 gallon tank se...

Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...

These gaskets should be changed when replacing the hinges, this one goes between the bootlid hinge on the body, see 24A2175 also for upper on bootlid.

These gaskets should be changed when replacing the hinges-this one goes between the bootlid hinge on the bootlid. See also 24A2176 for gasket on body.

Bootlid seal for Mini <91. Held in place on the boot lid using 26 clips(part# 14A6585).When fitting, the lip part of the seal open end for clips should face the inner boot catch- (the open end of the seal facing inwards to the bootlid al...

The MKI & MKII number plate panels 14A6468 are hinged at the top to swing out clear of the bumper when you open the boot lid. They were unavailable for years but now they're back. These & 14A6467 are the hinges.

Seal for door handles MK1/2 and all sliding window exterior hinge cars.

also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate



is oval shaped



for boot / rear door use the hole at the rear ...

GT emblem stick on logo for use on gearlever knobs and key fobs sold by us.

about 27.4mm wide, please note these are now black and silver not black and gold.

These are the little 'whisker clips' that hold the 14A9907 bezel on the front of the oval 3-instrument gauge pod 24A2702. The 'ears' slot into the back of the bezel and the tails that stick out go thru one of 14 holes in the...

Chromed version of the standard demist vent on early cars where the ashtray is

mounted in the top and middle of the metal facia. Not for later cars with large

padded windscreen rails and ashtray in the front such as Mini Clubman and...

This polished aluminium corner plate fits over the leading edge of the MKI/II door pocket to add protection and class. Only the Nearside plate is supplied.

"Remote" gearshift boots 22A608 are readily available in aftermarket quality. Unfortunately, this metal retaining band had been unavailable from normal sources so we at Mini Spares recently took it upon ourselves to have our own manufac...

The MKI & MKII number plate panels 14A6468 are hinged at the top to swing out clear of the bumper when you open the boot lid. They were unavailable for years but now they're back. These & 14A6466 are the hinges.

Front Ashtray with Solid top as used in the top dash rail when vinyl covered, from 1961-71, Most deluxe and Cooper variants. See 8D2490 for fluted ash tray as fitted to painted top dash rail 1959-85