Minis most used rubber plug 1.25" wide for holes approximately 7/8".

Fits floor, aerial hole and steering column extra hole and radius arm shroud on MK1/2 minis.These floor plugs vary in number from 11 in a Elf/Hornet,Mk1 and 1994 on cars do...

Bracket from the centre of the transmission tunnel up to the centre of the back seat pan

Original MK1/2 shape with correct 1.25" small neck.

Originally made by Winguard these plastic washer bottles for early Minis were often asked for but rarely available.

The original part number for the Winguard MK1 bottle was ADA383...

Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.



Also suitable for Twin Point indicator fixings.

Genuine MK3 wind-up window upper slide up and down felt lined channel that fits into the upper door frame. Left (PAM3077) and right (PAM3076) look identical but are mirror images.If you are looking for a cheaper budget version see PAM3077MS

...

Minis Spares product to a slightly higher modern day shore hardness and texture soecification.

Pre 1976 used 8 of these bushes for the trunnions on the rear subframe but from (MK4)1976 on Rover reduced the quantity to 4 and used 2 larger bus...

Black bushes for wiper wheelboxes. Sold as a wiper wheel box set(one above the windscreen scuttle cowl and one under the cowl), takes two sets per car.

To fit early Mk1/2 cars cut down the part that fits under the panel work part(this part h...

Mini Spares product from own original tooling since 1989.This small sheet metal panel mounts below the horizontal seam, covering the pivot pin of the R/H rear radius/trailing arm.

This shroud uses 14A7091 rubber plug not suppl...

Genuine Mini Spares mouldings product as supplied to Rover.

For wind up window cars 1970 on this is a set of inner and outer door brightwork mouldings with rubber seals attached to stop water running down the windows causing rust and to prev...