£1.41 exc vat
£1.69 inc vat
In stock
£1.41 exc vat
£1.69 inc vat
In stockRecommended usage 2 x RFR210 to fit one mini.
Originally welded to the inside of front panel. Made with stainless steel mesh grill and zinc electroplated.
Upper door moulding rivet for Cooper S door trim. For Mk1 usually 1 at front and 3 at back making 4 per side and on Mk2 there were 2 per end at bottom making 4 per side. This is the 10mm head rivet and not required on our own 14A9773/9774 trims that ...
High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.
Metal floor plug as per original with rubber seal.
For use in 1" hole.
Rear screen seal for mk1 cars which had the smaller rear window 1959-1967.
Complete fitting kit for the door check straps on all Minis fitted with external hinges.
Front subframe fitting kit for pre 76 twin bolt subframes, locktabs are included but not the subframe tower spacers as these rarely need changing.
Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.
10" blade MK1/2 with 6 sided nut for R/H/D or L/H/D with original 6 sided nuts. Right hand park, but you will have to disgard the nuts if you seek originality as after 1970 they became 8 sided or order correct kit for later type cars MSSK0...
Early Mini runner for metal type window catches pre May 1963 with sliding windows on the L/H front doors, these are the runners that hold the channel and have holes to lock the window catches. Now made in stainless steel by Minispares to ease rust pr...
Early Mini runner for metal type window catches pre May 1963 with sliding windows on the front doors, these are the runners that hold the channel and have holes to lock the window catches. Now made in stainless steel by Minispares to ease rust proble...
Protective wax Rover introduced to protect newly drilled holes in bodywork for such things as Badges. A small 10ml sachet only but ideal for any new holes drilled for wiring,screws and badges where metal could be left bare.
Thses were suppli...
Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge
Repair section of bottom of R/H door for external hinge cars, MK1/2.
this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...
part inner wing R/H from Damper bracket mounting points forward MK1 except Clubman. 1959-69 it has no air hole in side-see CZH3064 for later type with hose hole.
NON genuine panel
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.