MINI FUSE BOX PRE 76 2 FUSE
606253A

($5.50) £5.50 exc vat

($6.60) £6.60 inc vat

In stockIn stock
Fuse Box-Pre 1976

Early style twin fuse box as used on many cars and models. If your box is corroded, as most are, then the "Price of Darkness" is bound to strike you.

This is the 'later' early model with blade connectors and comes complete with cover. Replacement cover is 505158A.

($5.50) £5.50 exc vat

($6.60) £6.60 inc vat

In stockIn stock

Recommended usage 1 x 606253A to fit one mini.
Battery Fixings, Control/Fuse Boxes & Flashers Un - Qty 1

Recommended products

Replacement fuse. 35 amp was standard for the light circuit and the 'all other' circuit, too, on early cars with the two circuit fuse box.


If you don't remember where your spares are, or you've used them up, you may want to replenish you...

People also bought products

Inline fuse holder with approximately 7" of wire to replace the old original holders located under the scuttle panel which corrode over time.

30 amp maximum fuse for the engine fusebox and management link under the bonnet.

blade or double spade type fuse

Used on the following circuits: Heater blower motor, driving light relay, sunroof motor, wipers/washers, radiator cooling fan, indicators, stop-lights, reversing lights, heated rear window and front foglight relay.

Used on the following circuits: Headlight main and dipped beam, sidelights, alarm and instruments, rear foglight, headlight levelling, ignition auxiliaries, radio, airbag ECU, brake test switch warning light, indicators, clock, hazard warning lights,...

This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...

This later type oblong fuse box cover was fitted to the box that held 4 fuses as opposed to two and was fitted from 1976-1996.

Complete fuse box less fuses is RTC440A.

circuit breaker for safety as required in motorsport

The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...

Replacement fuse. 35 amp was standard for the light circuit and the 'all other' circuit, too, on early cars with the two circuit fuse box.


If you don't remember where your spares are, or you've used them up, you may want to replenish you...

Both personal safety and many sanctioning organizations require the use of switch for easy and complete cutoff of power from your battery. Easy to install and even provides a fused ancillary connection.

The most common use of this "great id...

Battery cut-off switch. FIA approved

Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...

Fuse box cover

If your fuse box is fine, but you've lost the lid, this is the cover for 606253A You DON'T want your bonnet prop falling directly on the fuse!

Black relay for the air con fitted mainly on export models 94-96 and some GB cars with carb before injection, 4 spade terminals and markings are Siemens V23134-B1052-C842 12v for 12 volt and R61-10

Economy battery cut-off switch.

Most race sanctioning bodies require the use of a kill switch for easy and complete cut-off of power from the battery. The switch has to be accessible from inside and outside the car; the external trigger...

Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.