WIPER MOTOR FITTING KIT
GXE7708FK

£11.25 exc vat

£13.50 inc vat

In stockIn stock
Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.

£11.25 exc vat

£13.50 inc vat

In stockIn stock

Recommended usage 1 x GXE7708FK to fit one mini.

Recommended products

Original manufacturer LESS THE GEAR 608092A this same wiper motor has been fitted since the late Mk2 version 1968/9 and is still used on the latest twin points but is wired up to give 2 speed and intermittent wipe.

The gear is ...

Wiper motor kit for all mk2 onwards cars, includes wiper motor, motor gear, wheel boxes, outer tube kit, wiper rack and wiper motor ferrule.

Kit contained products

Mk3 round body type wiper motors sat on this black rubber insulation pad

Upgraded Mini Spares product in stainles steel. You probably will never break this item, you're more likely to buy it for it's looks. This mounting strap fits all late model cars with the round wiper motor. The strap is polished stainless steel compl...

Large headed screw for safety. Short for securing the van petrol tank 21A291.3/4" long

White plasic nut (3 required) for the mini van/estate/pickup petrol tank. These smaller ones fit at the front with AB614061 screws (also fits the wiper motor strap). The 3 larger nuts on the rear are 21A304 and use [link]AB6...

People also bought products

Wiper motor kit for all mk2 onwards cars, includes wiper motor, motor gear, wheel boxes, outer tube kit, wiper rack and wiper motor ferrule.

Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.

Sports coil for ballast resistor type ignition.

Best internal parts tested and another intermotor top product.

Its not the name on the outside but whats on the inside which matters.

Original type coil bracket 12G29...

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.

For those very early 25D type distributors.Mini Spares version for modern fuels as fitted to our distributor range with slide on vaccum hose inlet pipe-not the very first screw in type

Screw for holding PRC1230A to the number plate light body, 1970 onwards.

Screw for chrome metal number plate lamp on mk3 19790 on - You will have to drill the lens out to take M4 screw.

Interior lamp with square blunt ends. This part superseded 13H192 which originally had the black on/off switch which BMC also fitted as an alternative. Fitted from October 1964 when courtesy light switches were introduced on Cooper from body number 3...

Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.

Double bullet connector used to join the front loom to the rear loom enar the wiper motor.

This is the plug for post 1976 rocker switches except the hazard switch which uses PM03, includes 5 pins so you can wire accordingly. SeePM07 for same headlamp plug but with correct loom repair wire colours,as that is the on...

Foam gasket that goes between the indicator/side lamp unit and front panel for all clubman models

Front loom only. MK4. Center speedo,inertia starter,rear fog switch.

non ballast coil,last with centre clock

A Plus Electronic Ignition distributor with vac unit, modified to our spec in UK to give best performance on any minis with std to 276 camshaft profile.

Ideal for our EVOLUTION001 camshaft

Brand New distributor complet...

THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.

3 per lamp required or 6 per car set.

Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...

Cooper cars with HIF44 carb from 1990-91 R/H/D with pre engaged starter,side repeater lamps on wings, 3 clock instruments--The Cooper LE(RSP) 1990 model has different loom listed as YMC11388 but this loom has been used by trade customers...

THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...

Fits the end of the wiper motor to hold the outer casing to protect the rack cable which drives the wheel boxes. Not supplied with new motors.