SCREW, 1.25" long for securing 21A291 van petrol tank.

White plasic nut (3 required) for the mini van/estate/pickup petrol tank. These smaller ones fit at the front with AB614061 screws (also fits the wiper motor strap). The 3 larger nuts on the rear are 21A304 and use [link]AB6...

Metal petrol pipe with tank union, this is for all estate and van versions with a mechanical pump where a long full length pipe is required. Made in non rust

metal.

Non Genuine reproduction tank fits all the long wheel base Minis, except for the very early side-tank travellers. Also used on many kit cars and specials owing to its shape.

Because of the outside location of these tanks, the originals seem ...

Rear screen seal for mk1 cars which had the smaller rear window 1959-1967.

Non-genuine version of the choke cable fitted to the early minis which does

not lock into place like the twin carb version. (see 21A1204).



It was made to work with the single HS2 carb and had only the word "CH...

Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.

Van R/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length -plain pressed floor with indents but no carpet brackets or lugs underneath.

Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...

Good quality pressing rear upper side panel,used for converting clubman estates to van sides or repairing van upper section back to original when windows have been fitted. This is RH side.

For MPI only when bonnet hook has been moved to central position.



This plate protects the bonnet lander panel from the hook and acts as a stiffener also. Stainless steel version.

This is the Clevis pin for the hook part with a spring and spacer only. This fits all Minis and Clubmans as the bracket it attaches to is on all bonnets unless broken. The spring loaded catch is designed to keep the bonnet from blowing open while dri...

Original shape washer jet for Mk1/2 minis. Made to the same specification as the last type made for rover parts sales with a nut on a loose thread so it can be tightened easily by hand in the engine bay without any modifications. Should be used with ...

Replacement screws and nylon inserts for the Van, Estate and Pick up petrol tanks.