Electric water gauge as standard on the centre binnacle Mini. Marked "C-N-H" Genuine Smiths. For post 1964 vehicles with voltage stabiliser fitted on speedo.

The early type had 3 connector tabs on one long brass strip for wires where as thi...

This unit fits directly on to the gearbox in place of the standard cable and produces a digital signal for use with any electronic speedometer requiring 12 or 5 volt square wave pulse such as our electronic speedo 13H4443. Fits post 1980...

This unit fits directly on to the gearbox in place of the standard cable and produces a digital signal for use with an electronic speedometer requiring a 5 volt square wave pulse such as our electronic speedo 13H4443. For pre 1980 speedo...

The black plastic pod which mounts the speedo and two gauges in the original central position. In the 1970's and 1980's a great number of Mini owners caught the customizing bug and a lot of Minis had custom dashboards installed. Now we're going the o...

Smaller 52mm face and reading 0-80 x100-If you are serious about your driving then you want to understand how your engine is responding to your urges. Many types of tachs are available in the aftermarket but since we drive British it should say "Smi...

Sealing washer for the oil gauge to oil pipe as sold in OL kit and for 21A804 metal pipe to oil gauge.

Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For any...

Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.

Oil pipe in plastic 5 feet long, if fitting to a Tim gauge you will require LMA017 adaptor for the gauge.

Not comppatable with the CAM6431 standard oli pressure block union, and OA shoudl be purchased to fit.

All Minis require an earth strap from the engine to the body and from 1959-1996

they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.

circuit breaker for safety as required in motorsport

The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...