DISTRIBUTOR 123 ELECTRONIC IGNITION NON VAC A+

C-27H7772

£243.00 exc vat

£291.60 inc vat

In stock

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For any A series, A Plus engines without vacuum unit. Dwell is microprocessor controlled, depending on coil current. Works with any standard or High Energy coil with a minimum 1 ohm resistance. Direct replacement for the Lucas distributor.Replacement cap is GDC123 and rotor arm is GRA123

'The 123 Distributor can be used with 6 or 12 voly power supplied from

the coil be it ballast resisted or not providing the coil has no less

than 1 Ohm resistance'.

Distributor drive spindle if required is 12G3560

Distributor clamp plate is TAM1671

Bolt for clamp is [linkTAM17076[/link]

£243.00 exc vat

£291.60 inc vat

In stock

Recommended usage 1 x C-27H7772 to fit one mini.

Distributors - Qty 1

People also bought products

DISTRIBUTOR CAP FOR 123 ELECTRONIC DISTRIBUTOR

GDC123

If you have a new 123 ELECTRONIC distributor this is the replacement cap.

For earlier 123 distributors please see part number GDC123E.

Rotor arm is GRA123

£21.00 exc vat

£25.20 inc vat

DISTRIBUTOR SPINDLE O RING SEAL

513682A

The O ring that actually sits on the distributor drive spindle shaft in the recess provided.

£0.48 exc vat

£0.58 inc vat

LUMENITION FOR 45D DIST ON

MTK007

Electronic ignition kit to fit 45/59D4 distributors.

Designed to do away with points this is a simple drop in installation to fit into your existing distributor. Also see our range of distributors with built in electronics--BAU1962MS & [lin...

£112.50 exc vat

£135.00 inc vat

DISTRIBUTOR CLAMP FOR A PLUS DIZZY 85 ON

TAM1671

Prong type clamp that bolts to the block and retains the A plus distributor in place. The screw is TAM1706.

Pre A plus clamp is 501134

£6.00 exc vat

£7.20 inc vat

PERFORMANCE 8mm PLUG LEAD SET RED

C-27H7779RED

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

£13.19 exc vat

£15.83 inc vat

COIL BRACKET 1969-95 LUCAS TYPE COILS STAINLESS ST...

12G2994SS

Stainless steel coil bracket for 1970-1996 cars.

£9.45 exc vat

£11.34 inc vat

COIL ORIGINAL SPORTS GOLD PERFORMANCE TYPE

MSC105

Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...

£20.70 exc vat

£24.84 inc vat

ROTOR ARM FOR NEW 123 ELECTRONIC DISTRIBUTOR

GRA123

Replacement rotor arm for the Electronic 123 range of distributor.

£8.63 exc vat

£10.36 inc vat

ROTOR ARM FOR ELECTRONIC DIZZY 1990-96

GRA2143

Rotor arm for all A series electric distributors when points are not fitted, except for turbo. The distributor cap for this rotor arm is GDC156.

£1.80 exc vat

£2.16 inc vat

NGK SPARK PLUG TUNED ROAD ENGINES

BP7ES

A higher compression engine should have a colder spark plug. The engineers explain that it has to do with flame temperature and overheating the plug. I know from experience that my race engine will melt a street plug. Choose from the following NGK pl...

£2.10 exc vat

£2.52 inc vat

ROTOR ARM FOR 45D/59D SEE GRA2130 FOR RELIABILITY

GRA2114

Post '74 cars with points or electronic distributors use this rotor arm.

If you originally wanted an upgraded version, the Turbos used the blue type cap and points GDC143 and GRA2130 respectively to contend with ext...

£2.43 exc vat

£2.92 inc vat

DISTRIBUTOR CAP ELECTRONIC IGNITION

GDC156

This was the first mini distributor cap to have screws hold the cap to the body from about 1990 on, when electonic ignition was introduced. Therefore there is no points or condenser but the rotor arm to use is GRA2143. Fits all 1992 onwa...

£5.45 exc vat

£6.54 inc vat

COIL FOR ELECTRONIC IGNITION - '89 ON

GCL143

This is the standard non ballast coil as used on the late Mini with factory electronic ignition for use with 65D distributor.0.9ohms.

GCL143 was the Genuine Rover part fitted part on 1275cc from 1990.

0.9ohms

GCL2...

£20.69 exc vat

£24.83 inc vat

NGK SPARK PLUG 998/STD 1275

BP6ES

Slightly hotter running engine plug for A Plus 998 and all 1275cc standard engines. For engine running CR of 9.4 to 10:1

£2.20 exc vat

£2.64 inc vat

PERFORMANCE ROTOR ARM - 45D/59D TYPE

GRA2130

The original blue rotor arm was fited with a blue cap GDC143 to the turbos and were made stronger by moulding and riveting the contact plate to the arm, so if you are looking for an upgrade on your 45D body distributor this is our altern...

£9.00 exc vat

£10.80 inc vat

HT LEAD SET RED SILICONE FROM LUMINITION

HV22

100% silicon insulation, silicon coated suppressed conductor,braided glass reinforcement,increased working temperature 0f minus 50C to +300 degrees with improved resistance to damp and water, great fitting and spiral bound wire giving instant and gre...

£29.25 exc vat

£35.10 inc vat

STAINLESS STEEL COIL BRACKET

8B12397

Also see 8B12398 which also includes coil cover sleeve in stainless steel.

£6.84 exc vat

£8.21 inc vat

NGK SPARK PLUG HIGH TUNE ROAD / RALLY