DISTRIBUTOR 998 59D ELECTRONIC A PLUS

Electronic Distributor for any standard A+ 998cc. Negative earth only.

From 1982on 998cc were fitted with a ballast coil which means a new wire must be fitted from fusebox top left terminal where there is a large white cable to the...

£75.00 exc vat

£90.00 inc vat

DISTRIBUTOR 123 ELECTRONIC IGN WITH VAC PRE A+ POS...

C-27H7771P

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For an...

£292.50 exc vat

£351.00 inc vat

PROGRAMMABLE 123 ELECTRONIC DISTRIBUTOR A+

C-27H7775

If you want to tune your engine, or you have an engine for which there is no standard distributor available.....the new 123\TUNE is the answer ! By connecting it to a computer, the end-user can easily adapt the 123\TUNE to fulfill even the most deman...

£337.50 exc vat

£405.00 inc vat

O RING SEAL ON DISTRIBUTOR HOUSING PRE A+

13H2792

the oil seal to fit on 12A1136 distributor housing. Pre A Plus

the earlier housing 2A612 did not have a seal.

£0.85 exc vat

£1.02 inc vat

ROTOR ARM FOR 25D TYPE PERFORMANCE TYPE

GRA101

If you have an original 25D type distributor this is an upgraded arm (blade moulded and riveted )for performance use because all the other types available now are likely to fail at high revs. Because the blade is thin,or the rivet sometimes to long a...

£12.00 exc vat

£14.40 inc vat

DISTRIBUTOR 123 ELECTRONIC IGNITION WITH VAC A+

C-27H7773

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 pre programmed advanced curves built in, a must for any mini with a worn distributor. Full instructions are included with the system. For any A series, A Plus engines...

£277.50 exc vat

£333.00 inc vat

DISTRIBUTOR 123 ELECTRONIC IGNITION NON VAC A+

C-27H7772

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For any...

£243.00 exc vat

£291.60 inc vat

DISTRIBUTOR 123 ELECTRONIC IGNITION WITH VAC PRE-A...

C-27H7771

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For an...

£277.50 exc vat

£333.00 inc vat

DISTRIBUTOR 123 ELECTRONIC IGNITION NON VAC PRE-A+

C-27H7770

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system.For any ...

£243.00 exc vat

£291.60 inc vat

DISTRIBUTOR SPINDLE O RING SEAL

513682A

The O ring that actually sits on the distributor drive spindle shaft in the recess provided.

£0.48 exc vat

£0.58 inc vat

VACUUM PIPE ELBOW

12B2062

The stock vacuum advance distributor is connected to the carb/manifold by a small rubber joint that in turn is mated to metal line that fits the distributor. If the little rubber connector is deteriorated it could allow a vacuum leak at the carb and ...

£2.25 exc vat

£2.70 inc vat

DISTRIBUTOR PIGTAIL WIRE AND PLASIC FITTING

37H2981

This "Pigtail" wire is all that carries current through the distributor to the points.Fits 23 and 25d type distributors

£9.38 exc vat

£11.26 inc vat

DISTRIBUTOR VACUUM UNIT 45D TYPE 54424152

37H8225

originally fitted to 1976-45D type distributors and 41824 distributor that fitted mainly 998/1100cc plus allegro and maxi a real jack of all trades we have found this works on all small bore engines with our new range of 45 and 59d distributor curve...

£17.00 exc vat

£20.40 inc vat

DISTRIBUTOR CAP DUCELLIER MINI-METRO 998CC

GDC214

Originally a red cap but now supplied in black, it was only fitted to Ducellier type distributors which were fitted to Mini Metros plus a few 998cc minis.Contact set is GCS119 and the condenser is GSC2113. Rotor arm is [lin...

£7.54 exc vat

£9.05 inc vat

DISTRIBUTOR CLAMP FOR A PLUS DIZZY 85 ON

TAM1671

Prong type clamp that bolts to the block and retains the A plus distributor in place. The screw is TAM1706.

Pre A plus clamp is 501134

£6.00 exc vat

£7.20 inc vat

CONDENSER FOR 23/25D DISTRIBUTOR

GSC2111

for 23/25D distributor but see [link]47H5250[/link} for resin type upgrade with 3m of wire as opposed to every aftermarket type analysed with only 1.5m of wire.

its worth paying extra for the condenser and rotor arm [link]GRA101]/link]

£2.45 exc vat

£2.94 inc vat

DISTRIBUTOR CAP 45D/59D

GDC136

Fited to Lucas type distributors with 45D body in 1974 until 1990 when electronic type that was held on by 2 screws appeared as oppossed to this clip on this type. If you need a new distributor clip-we have them as GDC136CLIP.

£4.49 exc vat

£5.39 inc vat

25D DISTRIBUTOR CAP SIDE ENTRY

GDC102

this is the original mini distributor cap where the leads were secured by screws and was fitted to the 25D range of lucas distributors. This cap had side entry leads [link[GHT101]/link] and is now only available from one or two manufactures owing to ...

£15.96 exc vat

£19.15 inc vat

PERFORMANCE 8mm PLUG LEAD SET RED

C-27H7779RED

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

£13.19 exc vat

£15.83 inc vat

NGK SPARK PLUG COPPER CORE STANDARD TUNE

B6ES

best plug for 12g295 head as fitted to 998 cooper--for tuned head use B7ES.

this is good for any head where a lot has been machined off-flat top pistons.

£3.20 exc vat

£3.84 inc vat