£106.00 exc vat
£127.20 inc vat
In stock
£106.00 exc vat
£127.20 inc vat
In stockRecommended usage 1 x 14A6564-MK1 to fit one mini.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Complete rear back panel section from roof to bumper valance with MK1 lamp and bootlid apertures but the backlight(rear window screen) aperture is only for models from 1967 to 2000. This panel is Not available genuine with the original MK1 size rear ...
The boot floor (trunk of the Mini) has always been an area with a great potential to rust. Not only is it often exposed to battery acid but typically water collects there and rust results. BM Heritage produce a sub assembly from original tooling tha...
BARE BULKHEAD SKIN
THIS IS THE LATER MPI PRESSING, BUT CAN BE CONVERTED TO SUIT EARLY CARS BY EITHER CUTTING ROTADIP HOLE YOURSELF, OR BY FITTING THE PRE FORMED HMP441017
A VERY CHEAP PANEL THAT CAN BE CUT TO MAK...
Genuine panel that has the holes for wipers and jets with only a few inches of pillar which is basically the area that rots. Also referred to as the windscreen scuttle lower panel. Fitting the genuine type ensures you should get a better windscreen a...
These 4" wide sills are genuine Rover replacement parts with 6 vents and are for MK3on saloon. Non Genuine is MS63L and a superb copy.
Most/many 1970 cars and Cooper S mk3 had 4 flutes.
They will fit MK1/2 but not origi...
These 4" wide sills are genuine Rover replacement parts with 6 vents and are for MK3 on saloon. Non Genuine is MS63R
Most/many 1970 cars and Cooper S mk3 had 4 flutes.
They will fit MK1/2 but not original fitment. Clos...
The bracket fitted to the boot board and is not in any kits.
When a boot board is fitted the following brackets are required
14A9780x2 U shaped for the rear to hold the board
14A9781x2 side bracket with plug for board to si...
The last type of rod change rib design floor made for the assembly line fits cars from 1973-96-It has a large rib down the centre of the L/H side
This floor produced from genuine tools has the crossmember fitted with the sill panels and ja...
When a boot board is fitted the following brackets are required
14A9780x2 U shaped for the rear to hold the board
14A9781x2 side bracket with plug for board to sit on except elf/hornet
14A9782x1 centre bracket with support ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.