WING INNER ONLY L/H ROUND FAN HOLE 1991-96
ABD36007

£195.00 exc vat

£234.00 inc vat

now

£165.75 exc vat

£198.90 inc vat

In stockIn stock
Inner l/h wing with large fan hole from 1991-96. This panel is available with the A panel fitted for ease of fitment as ABD36005

Was ABD36009 but that did not have the stiffener plate for the damper bracket fitted which was difficult to remove from an old damaged or rusty original panel.

£195.00 exc vat

£234.00 inc vat

now

£165.75 exc vat

£198.90 inc vat

In stockIn stock

Recommended usage 1 x ABD36007 to fit one mini.
Saloon and Front Ends - Qty 1

Alternative products

Inner front L/H wing with the A panel and door stiffener check strap panel attached for ease of fitment and alignment.This has the large round hole for the fan as fitted from 1991on

People also bought products

Repair section of bottom of door for external hinge cars, MK1/2.

This crude non genuine parts is the only repair section available for early doors apart from door skins.Lots of stretch marks and wrinkles but they have been fitted by customer...

Repair section of bottom of R/H door for external hinge cars, MK1/2.

this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...

non genuine L/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skinCZH3301

Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.

Front A panel part of door frame for internal hinge cars Left hand.Non gen

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

L/H narrow 6 flute outer sill for mk3 saloons to 2000 but most 1970 cars and Cooper S mk3 had 4 flutes--Great quality and fitting aftermarket panel

ADAPTOR PANEL TO CONVERT LATER FRONT PANELS TO THE PRE 1964 FULL SKIRT FRONT PANEL.

Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28R.

For Mk3 but can be used as a part of repair sectiion for Mk1/2

Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28L.

For Mk3 but can be used as a part of repair sectiion for Mk1/2

O/S/F wing t for 1996 on cars. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replace or renew the stiffener lip ALR360380

Has the headlamp re...

Slat type front grille section for mini van which will need trimming before welding into recess of either an original damaged front panel or a saloon version.

It is sold as a grille size panel and can be fitted as such when painted with [li...

L/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3

this is a genuine heritage part.

R/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3

this is a genuine heritage part.

Floor pan section with late type outer sill with inner sill all fixed to the floor pan which goes to the edge of the centre tunnel . The jacking point and strengthening bracket are all part of this useful R/H repair section

Floor pan section with late type outer sill with inner sill all fixed to the floor pan which goes to the edge of the centre tunnel . The jacking point and strengthening bracket are all part of this useful L/H repair section

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

Really a built up half front end for the mini clubman, consists of a lower panel with headlamp panels,slam panel and stiffener between the front and slam panel. 76 ON--no inner or outer wings

Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.