£0.70 exc vat
£0.84 inc vat
£0.70 exc vat
£0.84 inc vat
Recommended usage 8 x AD608084 to fit one mini.
m6x10 bolt--ideal for radiators with metric fittings (6 required for rads)
original imperial radiator screws were SH604031 or PK type were ARA1117
THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.
3 per lamp required or 6 per car set.
Clutch housing bolt to engine long 5/16" UNF 1.75" long with tuflock patch to secure. Earlier bolts less tuflock are {link]BH605141{/link}
M10 metric flanged bolt 35mm long for catalytic converter. (4 required per unit)
Plain half thickness half inch nut as used on our C-AJJ3365 arms and steering rack adjustment nut for track rod ends.
THE M10 METRIC NUT THAT SCREWS ON THE THREAD BOLTS OF THE CATALYLITIC CONVERTER
Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.
Also suitable for Twin Point indicator fixings.
Originally made to go on the heater tap studs on the cylinder head these are 1/4" unf for any other use to brighten uo your car. If you want the whole anti corrosion set of nuts and studs for the heater tap see C-STR285.
Remote type gearboxes had four UNC bolts holding the long alloy housing to the differential case. These are the shorter two, 3/8"unc 1"long. The longer two are ZCS628.
Also the bolt to hold the starter motor.
Also the bolt for the [...
If you change your air control valve MLZ100090 on the inlet manifold on Twin point injection engines you have to use these new different screws. They do not come with the valve.Also fits MPI top rad bracket to slam panel.
Moustache whisker clip for MK 1 grille. The end pieces of trim on the MK1 grille moulding known as the moustache. If your MKI whiskers have been gone so long that the clips and rivets are missing. Usually 3 per side fitted, clips sold individually.
Fits top and bottom of the front damper and the lower rear damper to keep the bush from moving in the damper (shock absorber) eye sockets. 3/8"hole.
1.4mm thick by 24.6mm wide.
Large steering wheel nut for all pre air bag models, and a shakeproof washer 53K3480 must be fitted for safety reasons.1 5/16" spanner size 1.3125" wide (33mm).