£1.22 exc vat
£1.46 inc vat
In stock
The moulding 14A8009 was fitted to all minis until the introduction of factory fitted wooden dashes from about 1994 when it was phased out-
never fitted on twin point injection cars.
£1.22 exc vat
£1.46 inc vat
In stockRecommended usage 8 x 14A8010 to fit one mini.
The lower brightwork moulding for finishing off the lower dash, crash pad rail or on earlier cars the painted metal surface of the panel which holds the switch panel section.See 14A8010 for clip
This moulding was fitted to all m...
This is the ‘off white’ plastic speedo housing fitted to all models from 1960 onwards.
It is an exact replacement for the cardboard type fitted to earlier cars.
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
The classic Mini phone holder with USB replaces the existing chrome ashtray in the metal top dash rail
Key Features:
Plate is made from powder coated 3mm steel
Spring loaded clamp, hold phones between 5...
The classic Mini phone holder with USB replaces the existing ashtray in the padded dash rail.
Key Features:
Plate is made from powder coated 3mm steel
Spring loaded clamp, hold phones between 59mm to 106...
The Classic mini ashtray replacement digital clock has been designed to seamlessly replace the ashtray insert to ensure the integrity of your classic mini dashboard is maintained whilst introducing the modern technology of our digital clock and optio...
Fresh air vent for the dash, these bolt to the bulkhead and the eyeball socket vents fit into them. These used to be handed but this vent has both hole patterns so will fit both sides. This replaces 37H7035, 37H7036, JJB101000 and JJB101010. Sold ind...
Clip under front floor fitted to 1990 for holding fuel/ brake lines (2 per car)
located beside floor pan footwell and tunnel
Clip for underside of front floor(3 per side) 6 in total fitted to 90
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Left hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut.
Alloy dash for cars with 3 clock pod in front of driver + 3 auxilary gauges and L/H/D--these dashes have a knob on the glovebox.
Alloy dash for cars with 2 clock pod in front of driver and L/H/D--these dashes have a knob on the glovebox.
This is the small plastic nut used to hold the fuel line protector shield on later cars, also used to hold the catalytic converter heat shield on, 4 required for each shield.
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Right Hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut
The scrivet for holding the front of the rear wheel Sportspack arch and the rear of the front arch. Rover also used rivet RY612535 as an alternative.
Switch panel bracket 1987 onwards to suit later style choke cables.
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Printed circuit board for pre 1989 cars with Smith's 2 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.