PANEL 2/3 CLOCK OFFSET SPEEDO LHD
DT3048A

£59.42 exc vat

£71.30 inc vat

In stockIn stock
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Left hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut.

£59.42 exc vat

£71.30 inc vat

In stockIn stock

Recommended usage 1 x DT3048A to fit one mini.
Headlinings and Trim popular range - Qty 1
Seats and Trim-Mini Saloon MK4-1976-1985 - Mini Cl - Qty 1
Seats and Trim - Mini Clubman Estate 1970-1982 - Qty 1
Seats and Trim - Mini Non Cooper 1993-96 - Qty 1
Seats and Trim - Mini Cooper 1990-1996 - Pre MPI - Qty 1

People also bought products

Fresh air vent for the dash, these bolt to the bulkhead and the eyeball socket vents fit into them. These used to be handed but this vent has both hole patterns so will fit both sides. This replaces 37H7035, 37H7036, JJB101000 and JJB101010. Sold ind...

Special clip for the lower brightwork moulding 14A8009 for finishing off the lower dash, crash pad rail, or on earlier cars the painted metal surface of the panel which holds the switch panel section.

The moulding 14A80...

Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Right Hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut

Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

2 outer rings and 2 inner knobs which have to be stuck on.

Chromed version of the standard demist vent on early cars where the ashtray is

mounted in the top and middle of the metal facia. Not for later cars with large

padded windscreen rails and ashtray in the front such as Mini Clubman and...

The black vinyl covering that lays on your lower dash shelf.for cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)

Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...

Small details can make a big difference to a restoration. New covers for the defroster vents won't make your car run better, they probably won't even make the defroster work any better, but they sure look better. These come in flat black primer, read...

Dash liners without air vents for either side of the speedo on deluxe versions such as the Cooper S with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only.

see [li...

Dash liner black painted cardboard without airvents and oval hole for deluxe speedo cluster.Not for single speedo only cluster.For Vinyl leathercloth type see ALE2927

Black painted liners for deluxe cars with air vents and central speedo and 2 gauges.

Burr walnut wooden dash for cars with 2 clock pods mounted in front of driver for L/H/D cars only

Ashtray that sits in the upper padded dash on all vehicles with 2/3 clocks positioned in front of driver. Early cars had flat plastic tray face whereas later cars had crinkly type face which is the only type available- They all fit the same.

Dash liners with air vents for on de luxe versions with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only. The cardboard is cut out but the vinyl needs trimming when fittin...

Reproduction of the original type fireproof bulkhead sound-proofing foam insulation. These often detiriorate overtime and turn into a crumbly mess.



These are pre-cut for the mounting points and accessories that are on the bulkhead...

This woodrim steering wheel requires a centre boss to suit your particular car and is the best value and quality wheel around in its class. Brightwork 3 spoke

centre design.

This set will fit all Travellers and Estates built between 1966 until 1980. The kit contains a piece of carpet to fit the rear of the back seat and another piece to cover the rear floor area. For the earlier 4 piece kit pre 1996 with external tank se...

Static 3 point fixing front seatbelt with the female fixing on a stem.