DASH CARDS(OVAL WITH VENTS)BLACK PAINTED PAIR
VGA4188

£17.00 exc vat

£20.40 inc vat

In stockIn stock
Black painted liners for deluxe cars with air vents and central speedo and 2 gauges.

£17.00 exc vat

£20.40 inc vat

In stockIn stock

Recommended usage 1 x VGA4188 to fit one mini.
Headlinings and Trim popular range - Qty 1
Seats and trim - Mini MK3 - MK4 1969-1980 - Qty 1

People also bought products

The black vinyl covering that lays on your lower dash shelf.for cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)

Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...

Dash liners without air vents for either side of the speedo on deluxe versions such as the Cooper S with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only.

see [li...

Pair of black painted type dash cards without airvent holes and for the single speedo only such as van or early saloon. If you have the deluxe type with oil and temp gauge see VGA4192 or in vinyl see ALE2927

Dash liner black painted cardboard without airvents and oval hole for deluxe speedo cluster.Not for single speedo only cluster.For Vinyl leathercloth type see ALE2927

Dash liners with air vents for on de luxe versions with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only. The cardboard is cut out but the vinyl needs trimming when fittin...

The classic Mini phone holder with USB replaces the existing ashtray in the padded dash rail.



Key Features:



Plate is made from powder coated 3mm steel

Spring loaded clamp, hold phones between 59mm to 106...

The Classic mini ashtray replacement digital clock has been designed to seamlessly replace the ashtray insert to ensure the integrity of your classic mini dashboard is maintained whilst introducing the modern technology of our digital clock and optio...

This strong felt backed PVC material will help with noise reduction. When removing the speedo panels in your Mini you may find some thin felt. We have produced a replacement sound deadening that fits behind the speedo panels, reducing noise and vibra...

Fresh air vent for the dash, these bolt to the bulkhead and the eyeball socket vents fit into them. These used to be handed but this vent has both hole patterns so will fit both sides. This replaces 37H7035, 37H7036, JJB101000 and JJB101010. Sold ind...

Special clip for the lower brightwork moulding 14A8009 for finishing off the lower dash, crash pad rail, or on earlier cars the painted metal surface of the panel which holds the switch panel section.

The moulding 14A80...

Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Left hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut.

Works Dash for LHD cars.

The later type more common dashes as used on the classic works Monte Minis and rally cars from ST Abingdon.


In crackle black finish.


Attaches to top and bottom parcel shelf rails either side...

2 outer rings and 2 inner knobs which have to be stuck on.

Bezel for 24A2702 oval 3-gauge pod. This is the brightwork trim on the front of the plastic pod, it is held on with up to 14 whisker clips 14A9796. The clip to join the ends together for neatness is 24A472
<...

Chromed version of the standard demist vent on early cars where the ashtray is

mounted in the top and middle of the metal facia. Not for later cars with large

padded windscreen rails and ashtray in the front such as Mini Clubman and...

The black plastic pod which mounts the speedo and two gauges in the original central position. In the 1970's and 1980's a great number of Mini owners caught the customizing bug and a lot of Minis had custom dashboards installed. Now we're going the o...

ALSO SUITABLE FOR EARLY MK3 CARS THAT RETAINED THE DASH MOUNTED STARTER SWITCH AND TOGGLE SWITCHES CARRIED OVER FROM THE MK2 CARS.THE CHROME TRIM FOR THIS IS ALA6640

Small details can make a big difference to a restoration. New covers for the defroster vents won't make your car run better, they probably won't even make the defroster work any better, but they sure look better. These come in flat black primer, read...