This is the kit supplied with our C-AHT772, C-AHT773 & C-AHT774 range of alloy inlet manifolds for the weber.

complete kit of bushes and bolts for pre 1976 rear subframes when 8 rubber bushes the same size are used--for cars after 1976 with 4 small and 2 large rubber bushes use MS43

Rubber mounts are made in the UK.

Conversion mount kit, with fittings to allow the fitment of a manual engine to an automatic front subframe.



Will require to elongate the 2 upper holes on subframe equally, once subframe holes line up with the spacer plate in this k...

This kit contains all the parts from MS44 plus the 4 cast trunnions that hold the rubber bushes. This complete rear subframe fitting kit is what the factory fitted to minis up to 1976 on but the later kit MS41 will fit early...

Front subframe fitting kit for pre 76 twin bolt subframes, locktabs are included but not the subframe tower spacers as these rarely need changing.

All the Nuts, bolts and washers you will need to fit a rear subframe to your car, less the support pins and bushes. These kits are aimed at those wanting to fit different rear subframe bushes such as the Poly bushes.

Engine mount bolt kit for manual cars, 1 kit requried per car.

Plain washer 3/16" or 2BA.

Fibre washer to go under 12A1436 metal washer on the twin HS2 carb air cleaner. One required for HS4--sold singly order as required

New set of metric studs, bolts, nuts and washers as supplied with the alloy external hinge kit (PEASE NOTE: This kit is NOT suitable for the original hinges). The studs have allen key socket ends to help put them into the hinge easily without damage,...

Flat 1/2" washer, 2.24mm thick approx.

Spring washer 7/16" x 11/16".Sold singly

Sold individually

This special shake proof washer should be replaced. Found on front hose.

Also used on 21A1524 hydrolastic pipe adaptor.