For 850, 998, 1100 cylinder heads where there is no sandwich plate under the thermostat housing.

Fits from the thermostat housing and end manifold stud. The other end bolts to the bulkhead where the heater hoses go through the body.

complete kit of bushes and bolts for pre 1976 rear subframes when 8 rubber bushes the same size are used--for cars after 1976 with 4 small and 2 large rubber bushes use MS43

Rubber mounts are made in the UK.

All the Nuts, bolts and washers you will need to fit a rear subframe to your car, less the support pins and bushes. These kits are aimed at those wanting to fit different rear subframe bushes such as the Poly bushes.

Plain washer 3/16" or 2BA.

Fibre washer to go under 12A1436 metal washer on the twin HS2 carb air cleaner. One required for HS4--sold singly order as required

New set of metric studs, bolts, nuts and washers as supplied with the alloy external hinge kit (PEASE NOTE: This kit is NOT suitable for the original hinges). The studs have allen key socket ends to help put them into the hinge easily without damage,...

Flat 1/2" washer, 2.24mm thick approx.

5/16" flat plain washer.

This special shake proof washer should be replaced. Found on front hose.

Also used on 21A1524 hydrolastic pipe adaptor.

Fits top and bottom of the front damper and the lower rear damper to keep the bush from moving in the damper (shock absorber) eye sockets. 3/8"hole.

1.4mm thick by 24.6mm wide.