£50.35 exc vat
£60.42 inc vat
In stock
£50.35 exc vat
£60.42 inc vat
In stockRecommended usage 1 x AN140 to fit one mini.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Dip switch lead for left hand drive cars, these are not included with new looms.
Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.
mainly for 1980-1...
Front and rear loom for 60-62 Mini pick up, braided with floor start.
Was HAM3066 main loom less the wing side repeaters but superseded by Rover to this loom with side repeaters on wing,although the manufacturer of these looms always added them to HAM3066 anyway -Inertia starter, Ballast coil, Instrument cluster in fro...
We sell about 20 of these per year and many are used on similar models to those indicated-Main and dash loom only--No side wing indicators-indicator stalk on right-alternator-rear lamps with reverse lights-steering lock-inertia starter-centre speedo ...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
Originally for mini special 20th edition which had 2 clock speedo cluster in front of driver and AAU3296 (ADO16)wing indicators.The special also had 1100cc engine. This front loom only has found its way on certain mini clubmans with corr...
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
998cc minis with central speedo and alternator from 1972-75. This is a front loom only.
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Basically just the rear lamps and number plate lamp wiring loom for mini van.
PVC covered rear loom only for Mk2 with heated rear screen.
Can be fitted to MK3 front loom ( HAM2174 ).
Braided rear part loom ONLY for MK1 Minis without a rear heated screen.
PVC covered loom for 1275GT models with alternator from 1970 to 1976. For dynamo version of this see AN127.
Basic spec is: side instrument pack, single stalk, MK3 rocker switches, round single speed wiper motor, manual washer pu...
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
MAIN WIRING LOOM 1969 TO 1976 MK3 998 MINI AND COOPER S. ALTERATOR/PVC COVERED.
Complete with rear loom for electronic fuel pump.
Basic spec is: centre speedo oval dash, single stalk, toggle or mk3 rocker switches, inertia starter, ...
This plug fits the hole in the inner wing where the wiring for the wing side repeater lamp goes through the body on cars after 1986.
Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.