NEEDLE ABH SWINGING
CUD1031

£8.25 exc vat

£9.90 inc vat

Out of stockOut of stock

£8.25 exc vat

£9.90 inc vat

Out of stockOut of stock

People also bought products

This needle is richer than used in our stage one kit but is useful when slightly different mods are carried out.

A very usefull tuning needle for single and twin carbs when camshaft change for carbs with floating needles.

The new adjustable height StayUp® Float is resistant to modern ethanol based Fuels and has a military spec closed cell construction making it puncture proof. The ability to adjust the Float Arm allows for quick and easy minor alterations to Float lev...

Plain butterfly disc kit for the HIF38 carb,which we sometimes order in in as requested by the customer as they are very slow selling--same size butterfly on all 1.5" carbs

This is the original type of needle valve that governs the plastic fuel float in your SU carb.

An alternative better upgraded version is available as CA90.

The metal washer AUD2193 goes up against this seal on the jet where it enters the float bowl on all HS type carbs.

Standard spring for all HS2 and HS4 on minis except for the 997/998 Cooper from 1964-9 and H4 special tuning carbs which used AUC4587.

For HS4 single pre waxstat carbs with red jet this is the full rebuild kit with the spindle and plain throttle disc and bushes--- see CRK227 for disc with overrun valve.

Float grommet for the mini twin HS2/4 carbs---this 30 degree angle is for the L/H ( front) carb and is positioned to angle the float bowl--Used on both twin HS2/4 carbswhen using correct mini inlet manifolds- Midgets and MGB used different angles,u...

This seal sits against the head of the bolt that holds the float bowl on the other side of the body on HS2/4 twin carbs only.sold singly,2 required per car

yellow identification spring which is heavier than AUD4355 and is an optional extra. For HIF carbs only.

The pin that holds the float bowl in place on the float bowl lid-See also AUE266 for complete lid with float bowl and needle valve fitted.

Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).

Float grommet for the mini twin HS2/4 carbs---this 30 degree angle is for the R/H ( rear) carb and is positioned to angle the float bowl--Used on both twin HS2/4 carbswhen using correct mini inlet manifolds-Midgets and MGB used different angles,usual...

Standard weight 4.5 ounce spring colour coded red for HIF type carbs only.

There is an optional heavier spring coloured yelow at 8oz.