Only this genuine wing is now available for the mini clubman but you will probably require the headlamp backing panel CZH120

1970 on, cars with internal hinges and wind up windows

This repair panel has holes for the hinges on A post and overlaps 3.5"(85mm)onto the wheel arch section of inner wing

The section forward from the damper (shock absorber) bracket area

these sections approx 20" long often rust around the areas where they weld to the front wings.

Non genuine L/H Van inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. For Mk1 VAN

Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.

Rear seat belt anchor mounting point as found on later cars. This panel needs to be welded into the C post.

Bracket on the end of the dash crossmember (x member holds master cylinders) under bonnet right hand side. The x member is AHC36003

Upgraded R/H "A" panel for all Minis with internal hinges,1970 on.

A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.

Only available from Mini Spares th...

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

Really a built up half front end for the mini clubman, consists of a lower panel with headlamp panels,slam panel and stiffener between the front and slam panel,

but not inner or outer wings