£5.00 exc vat
£6.00 inc vat
In stock
£5.00 exc vat
£6.00 inc vat
In stockRecommended usage 3 x CZH614 to fit one mini.
Minis most used rubber plug 1.25" wide for holes approximately 7/8".
Fits floor, aerial hole and steering column extra hole and radius arm shroud on MK1/2 minis.These floor plugs vary in number from 11 in a Elf/Hornet,Mk1 and 1994 on cars do...
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
Only this genuine wing is now available for the mini clubman but you will probably require the headlamp backing panel CZH120
Only this genuine wing is now available for the mini clubman but you will probably require the headlamp backing panel CZH121
Black bushes for wiper wheelboxes. Sold as a wiper wheel box set(one above the windscreen scuttle cowl and one under the cowl), takes two sets per car.
To fit early Mk1/2 cars cut down the part that fits under the panel work part(this part h...
Screw for the grille. 8 required. Number 8 also for door lock control assembly. Sold singly,8 maximum used
This a genuine half panel of the HMP441008-26"long for the left hand side
with fixings for subframe mounts.
Non genuine MS51L section repair panels are only 11" long-MS51L
Although used on vans with metal load ...
Complete car set of stainless steel screws for the piano hinge type opening rear quarter light windows.
High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!
Captive nut plate that sits behind the damper bracket on the inner wing/bulkhead to attach the damper brackets. 2 PER SIDE.
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.
FIA spec anchor plate for eye bolts, used when fitting harnesses. Sold individually, 7/16 UNF 65x65x3mm.
Screw for holding PRC1230A to the number plate light body, 1970 onwards.
Curley fibre glass Mini Miglia wheel arches, approximately 4.8." wide, with front edge 6.9" at widest point. Requires MS127FK brackets. Probably the largest wheel arches used on minis. Please note these are white gel coat not black and w...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.