DASHBOARD CARBON FIBRE 3+3 CLOCK L/H/D
DASH031

£219.80 exc vat

£263.76 inc vat

Out of stockOut of stock
Wooden 3 clock dashboard + 3 extra gauge holes cut out, with carbon fibre finish for LHD cars.

£219.80 exc vat

£263.76 inc vat

Out of stockOut of stock

People also bought products

Alloy dash for cars with 3 clock pod in front of driver and L/H/D--these dashes have a knob on the glovebox.

door cappings in carbon fibre to compliment carbon fibre finished dash

Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

2 outer rings and 2 inner knobs which have to be stuck on.

The black vinyl covering that lays on your lower dash shelf.for cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)

Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...

Lovely Burr walnut dash for left hand drive cars with 3 clocks in front of driver.

3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996


<...

Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the pre tensioner types fitted in Europe.



It will arrest the wearer within the same tolerances without a need for a...

Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the inertia reel type fitted from 1976 including the later pre tensioner type. Not suitable for MK1/2 saloons and vans/pickups due to...

White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...

Plain white with white backing aftermarket sun visor as fitted to Mk3 models 1977-92 which were thinner than Mk1 for safety crushing requirements. Although not standard for earlier models will fit cars from December 1965. Check out the special clips ...

Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...

Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow

number 1 with red ends is EEB100060

number 2 and 3 is white ends are both EEB100070

number 4 with black ends is EEB100080
...

Similar to those fitted as standard on the late Coopers this piece of trimming is purely cosmetic although it may help to eradicate some road noise that might get past the standard rubber gaiter--This is black with red stitching.

Bracket on the crossmember that holds the seat.

2 required per seat.

Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.

Rectangular grey plastic with white plastic interior lamp was fitted to minis from 1974 until 1985. 4.25" long and 1.75" wide. From 1984 on Rover recessed the lamp AFU4092 into the headlining. Fitted with GLB239 bulb. The le...

Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.