Original exhaust bracket for rod change gearbox but later on Rover reverted back to GEX7526 which seemed a bit of a backward cost cutting exercise.

Exhaust centre strap that hangs from the mounting on the centre of the rear subframe, for saloon models only as the van is longer(GEX7273).

The clip on the exhaust that this attaches to is GEX7052 and is usually on a new exhaust...

Exhaust manifold to downpipe clamp.

The key to eliminating exhaust leaks at the manifold flange is the clamp. These new clamps include proper brass nuts and support washers. Fits most 850cc, 948cc, 998 etc. Those engines with single carb an...

The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992. When the RC40 or similar systems are fitted, 2 will be required.

See C-19G3258 for larger upgrade...

This is the hanger on the rear of the rear subframe for all Coopers and cars with an RC40 exhaust system. The u bolt to fix this to the exhaust is GEX9007.

All the parts to hang RC40 exhausts systems are available i...

Exhaust hanger clamp for 1.875" pipe.

For joining rear box to downpipe on RC40 and downpipe to manifold on RC40.

Clamp on the front downpipe that fits to the bracket on the gearbox (GEX7526)

these are also supplied on our new 2 piece exhaust.

Exhaust hanger clamp for 1.75" pipe as per RC40 etc.

Metal gasket for the catalyst and is the same both ends for Cooper 1275CC RSP early cars, but only fitted on the front to later cars. If you cannot fit this gasket on the rear your car does not need one.

This is the hanger on the front of the rear subframe for all Coopers and cars with an RC40 exhaust system. The u bolt to fix this to the exhaust is GEX9008.

All the parts to hang RC40 exhausts systems are available ...