£4.15 exc vat
£4.98 inc vat
In stock
£4.15 exc vat
£4.98 inc vat
In stockRecommended usage 2 x GVC1021 to fit one mini.
Top quality clevis pin that retains the handbrake cable to the levers sticking out from the rear backplates.(levers are SMN10005). If the pins have any sign of wear change them as they cause extra play and function of handbrake.
Sold singly,...
Rubber gaiter to keep debris from entering the drum via the backplate handbrake lever SMN10005. Sold singly per backplate, 2 required per car.
Genuine AP Lockheed rubber boot
For mk1/2/3 Van,Pickup,Estate upto 1976 which had 2 cables from the lever.
FOR SALOON MODELS USE GVC2022
If your car has 2 cables running from the lever as per pre 1976 cars for dry suspension only but NOT VAN,PICKUP and ESTATE
From 1976 the handbrake cable layout was changed --instead of two cable from the handbrake it was changed to one. Front for the saloons is GVC2135 at 25" long and the van requires a 29.5" long cable which this one is. The cable between ...
This bracket is the main mounting bracket for the handbrake lever assembly and is welded onto the back of the seat crossmember and to the rear floor section.
Only for Pre rod change cars with twin cable handbrake.
The later type bra...
special shaped nut for handbrake cable at handbrake end
Twin cable use 2A5858
The rubber type grip fitted on handbrakes-
will fit any single cable hand brake from 1976 on
Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...
From 1976 the handbrake cable layout was changed, instead of two cables from the handbrake it was changed to one. Front for the saloons is 25" long and the van requires 29.5" long which is available as FAM625. The cable between the wheel...
Rubber gaiter to keep debris from entering the drum via the backplate handbrake lever SMN10005. Sold singly per backplate, 2 required per car.
special double coil spring washer which fits on the rear hanbrake quadrant on Hydrolastic cars only.Known as a thackery washer
The stock bare metal handle can be cold, clammy and slippery; this rubber grip slips on the handle for added comfort on all cars with twin handbrake cables.
The rear handbrake sector fitted to the rear radius arm on hydrolastic cars only
which was different from dry suspension types. Can use PFR109 clip to secure. 2 required per car but sold singly.
Concave washer for the CLZ549 pin on the quadrant of dry suspension minis.
Handbrake fairlead plate on the floor for the cable to go through. Make sure you renew the sealing washer SPK10002.
Top quality clevis pin that retains the handbrake cable to the levers sticking out from the rear backplates.(levers are SMN10005). If the pins have any sign of wear change them as they cause extra play and function of handbrake.
Sold singly,...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.