£37.80 exc vat
£45.36 inc vat
£37.80 exc vat
£45.36 inc vat
Recommended usage 1 x MS21L to fit one mini.
The rear doors of the Mini Van and Wagon are the same except on the Woodie were a wood frame is screwed to the sheet metal. The door has a inner and outer skin and should have drain holes in the bottom. When these plug up the resulting rust always ...
Captive nut plate that sits behind the damper bracket on the inner wing/bulkhead to attach the damper brackets. 2 PER SIDE.
Non Genuine reproduction tank fits all the long wheel base Minis, except for the very early side-tank travellers. Also used on many kit cars and specials owing to its shape.
Because of the outside location of these tanks, the originals seem ...
Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge
Repair section of bottom of door for external hinge cars, MK1/2.
This crude non genuine parts is the only repair section available for early doors apart from door skins.Lots of stretch marks and wrinkles but they have been fitted by customer...
Repair section of bottom of R/H door for external hinge cars, MK1/2.
this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...
part inner wing R/H from Damper bracket mounting points forward MK1 except Clubman. 1959-69 it has no air hole in side-see CZH3064 for later type with hose hole.
NON genuine panel
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Black door pocket liner for the R/H door which has sliding windows and external hinges
Black door pocket liner for the L/H door which has sliding windows and external hinges
A post and inner wing repair panel 8" wide for Mk1/2 saloon and MK1 Van/pickup
R/H side--6" from a post section
Small reinforcement bracket panel between the inner and outer sill on the LH side rear. The 24A43 slinger sits underneath this bracket under the sill panel.
Small reinforcement bracket panel between the inner and outer sill on the RH side rear. The 24A42 slinger sits underneath this bracket under the sill panel.
Small reinforcement bracket panel between the inner and outer sill at the front, these are the same both sides.The 24A41 slinger sits underneath this bracket under the sill panel
ADAPTOR PANEL TO CONVERT LATER FRONT PANELS TO THE PRE 1964 FULL SKIRT FRONT PANEL.
ADAPTOR PANEL TO CONVERT LATER FRONT PANELS TO THE PRE 1964 FULL SKIRT FRONT PANEL.
Slat type front grille section for mini van which will need trimming before welding into recess of either an original damaged front panel or a saloon version.
It is sold as a grille size panel and can be fitted as such when painted with [li...
The first panel up towards the dash after the floor pans, at an angle and where steering rack bolts to floor without any brackets or fittings, see also same panel with steering rack fitting AHA36006 for 1976 on rubber mounted subframe or...
Stiffener for inner sill for Van with metal load floor and Pickup L/H