£105.00 exc vat
£126.00 inc vat
now
£96.60 exc vat
£115.92 inc vat
In stock
Heritage use them on their Clubman shells but require modification and insets. This is the bare panel only i.e. no steering rack mounts etc.
£105.00 exc vat
£126.00 inc vat
now
£96.60 exc vat
£115.92 inc vat
In stockRecommended usage 1 x AHA36007 to fit one mini.
Complete car set of rear sliding window runners for Mini Estate and Countryman models.
Upper door moulding rivet for Cooper S door trim. For Mk1 usually 1 at front and 3 at back making 4 per side and on Mk2 there were 2 per end at bottom making 4 per side. This is the 10mm head rivet and not required on our own 14A9773/9774 trims that ...
High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!
Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
This is small plate that welds into the later lower dash rails to convert them to mk1 size for people who want early switches in a late car.
Complete fitting kit for the door check straps on all Minis fitted with external hinges.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
The last type of rod change rib design floor made for the assembly line fits cars from 1997-2000. It has a large rib down the centre of the L/H side.
This floor produced from genuine tools has the crossmember fitted with the sill panels an...
Front subframe fitting kit for pre 76 twin bolt subframes, locktabs are included but not the subframe tower spacers as these rarely need changing.
Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge
Van R/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length -plain pressed floor with indents but no carpet brackets or lugs underneath.
Van L/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length-plain pressed floor with indents but no carpet brackets or lugs underneath
Body side rear lower w/arch to rear section of bodyside repair R/H. 220mm tall.
part inner wing R/H from Damper bracket mounting points forward MK1 except Clubman. 1959-69 it has no air hole in side-see CZH3064 for later type with hose hole.
NON genuine panel
Wiper mounting kit for Mk1 Mini's (3 required per car). Each kit comes with a pin, nut, 2 washers and mounting rubber.
Genuine version of 14A8347.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.