£650.00 exc vat
£780.00 inc vat
now
£552.50 exc vat
£663.00 inc vat
In stock
This floor produced from genuine tools has the crossmember fitted with the sill panels and jacking points. Has mounts for pre tensioned seat belts and has a reinforcement strip over seat belt holes and a platform panel attached to tunnel and floor under rear seat, drivers side. Less rear companion boxes.
For floors with remote type gearboxes qoute 24A2615 available.
£650.00 exc vat
£780.00 inc vat
now
£552.50 exc vat
£663.00 inc vat
In stockRecommended usage 1 x ADA36002 to fit one mini.
Metal floor plug as per original with rubber seal.
For use in 1" hole.
This 9.5" rear section of the boot (trunk) floor is ideal for collision or rust repair. Many times if you are hit from the rear the floor right in front of the bumper gets damaged-this will fix it. If rust is your problem, then this along with a new ...
part inner wing L/H from Damper bracket mounting pointing forward for SPI modles 1991-96 with large round electric radiatore fan hole
NON genuine panel
Genuine version of 14A8347.
Genuine version of 14A8346.
Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.
Non genuine repair panel for below the lights and above the rear valance, fits all models. Left hand side.
O/S/F wing t for 1996 on cars. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replace or renew the stiffener lip ALR360380
Has the headlamp re...
Upgraded L/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
Upgraded R/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
L/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3
this is a genuine heritage part.
R/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3
this is a genuine heritage part.
Small angled bracket fitted by factory to stiffen front wings to A panels
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.
The whole front bulk head assembly with bonnet hinges on the lower dash panel, crossmember and toe board with start of rod change floor tunnel,reinforcements for holding steering rack and heater mounting points --made for vehicles from 1990 on with 1...
Complete rear back panel section from roof to bumper valance with MK1 lamp and bootlid apertures but the backlight(rear window screen) aperture is only for models from 1967 to 2000. This panel is Not available genuine with the original MK1 size rear ...
This inner wing has no radiator cooling fin slots or the round hole for electric fans and therefore is only suitable for cars with the front mounted radiator such as Twin points or specials.
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.