BULKHEAD ASSEMBLY COMPLETE FOR 1990 ON MODELS
AHA36005

£395.00 exc vat

£474.00 inc vat

now

£363.40 exc vat

£436.08 inc vat

In stockIn stock
The whole front bulk head assembly with bonnet hinges on the lower dash panel, crossmember and toe board with start of rod change floor tunnel,reinforcements for holding steering rack and heater mounting points --made for vehicles from 1990 on with 1275 engine-mainly injected cars. There is an earlier spec for rubber mounted cars only from 1976 to 1989, available as CZH3216



if you only need the bare skin look at AHA36008

£395.00 exc vat

£474.00 inc vat

now

£363.40 exc vat

£436.08 inc vat

In stockIn stock

Recommended usage 1 x AHA36005 to fit one mini.
Saloon and Front Ends - Qty 1

People also bought products
FLOOR PAN & X MEMBER FOR ROD CHANGE SALOON MPI
ADA36002

The last type of rod change rib design floor made for the assembly line fits cars from 1997-2000. It has a large rib down the centre of the L/H side.

This floor produced from genuine tools has the crossmember fitted with the sill panels an...

£650.00 exc vat

£780.00 inc vat

now

£552.50 exc vat

£663.00 inc vat
PANEL HINGE INNER L/H A PANEL EXTERNAL HINGE TYPE
14A8347GEN

Genuine version of 14A8347.

£70.00 exc vat

£84.00 inc vat

now

£64.40 exc vat

£77.28 inc vat
PANEL HINGE INNER R/H A PANEL EXTERNAL HINGE TYPE ...
14A8346GEN

Genuine version of 14A8346.

£70.00 exc vat

£84.00 inc vat

now

£64.40 exc vat

£77.28 inc vat
WING R/H FOR ALL 1996 ONWARDS TWIN POINT MODELS
ASB360009

O/S/F wing t for 1996 on cars. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replace or renew the stiffener lip ALR360380

Has the headlamp re...

£106.00 exc vat

£127.20 inc vat

now

£90.10 exc vat

£108.12 inc vat
A PANEL MK3 L/H NON GENUINE UPGRADE
ALA5661MS

Upgraded L/H "A" panel for all Minis with internal hinges,1970 on.

A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.

Only available from Mini Spares th...

£18.00 exc vat

£21.60 inc vat
A PANEL MK3 R/H NON GENUINE UPGRADE
ALA5660MS

Upgraded R/H "A" panel for all Minis with internal hinges,1970 on.

A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.

Only available from Mini Spares th...

£18.00 exc vat

£21.60 inc vat
WING TO A PANEL SUPPORT
14A7602

Small angled bracket fitted by factory to stiffen front wings to A panels

£2.30 exc vat

£2.76 inc vat
REAR BACK PANEL WITH MK1 LAMP CONVERSION
HMP441046

Complete rear back panel section from roof to bumper valance with MK1 lamp and bootlid apertures but the backlight(rear window screen) aperture is only for models from 1967 to 2000. This panel is Not available genuine with the original MK1 size rear ...

£310.00 exc vat

£372.00 inc vat

now

£279.00 exc vat

£334.80 inc vat
INNER WING L/H WITH NO RAD VENT HOLE FROM 1996
ABD360180

This inner wing has no radiator cooling fin slots or the round hole for electric fans and therefore is only suitable for cars with the front mounted radiator such as Twin points or specials.

£149.00 exc vat

£178.80 inc vat

now

£126.65 exc vat

£151.98 inc vat
INNER WING AND FLITCH PANEL Mk1/2 L/H
14A7901

For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not ...

£195.00 exc vat

£234.00 inc vat

now

£165.75 exc vat

£198.90 inc vat
INNER WING AND FLITCH PANEL Mk1/2 R/H
14A7900

For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to. This is the right hand panel made by Heritage but not 100% perfe...

£149.00 exc vat

£178.80 inc vat

now

£126.65 exc vat

£151.98 inc vat
INNER WING L/H MK3 INTERNAL HINGE TYPE 1970-89
ALA6475

this inner wing has the grille slats for the radiator cooling.

for MK3 cars with wind up window doors until 1991 when it changed to a large round hole for the cooling fan. If you require this panel with the A panel fitted for ease of fitment...

£145.00 exc vat

£174.00 inc vat
WING INNER VENTED AND A PANEL L/H 1969-91
ALA6279

This inner wing has the grille slats for the radiator cooling. Built into this panel also is the A panel and door stiffener check strap panel attached for ease of fitment and alignment for wind up window type doors 1969-89.

£239.00 exc vat

£286.80 inc vat

now

£203.15 exc vat

£243.78 inc vat
SEAT BULKHEAD PANEL REAR UPRIGHT
24A2204

This rear bulkhead panel is the actual panel the rear passengers back rest against where the upright seat squab is positioned. Not always carried in stock but usually available to special order--this is done to the last factory pressing with the loca...

£195.00 exc vat

£234.00 inc vat

now

£165.75 exc vat

£198.90 inc vat
FRONT WING R/H WITHOUT REPEATER HOLE
MS1R

Aftermarket wings do the job at a fraction of the cost of originals. This right front wing for the Mini will fit all MKI, II, III, IV. A slight difference exists between the early and the later models as to headlamp mounting holes. These reproduction...

£66.00 exc vat

£79.20 inc vat
FRONT FLOOR PAN L/H PRESHAPED
MS25L

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...

£33.00 exc vat

£39.60 inc vat
FLOOR PAN RODCHANGE
CZH2669

Floor,Front and rear assembly for Rod change gear lever cars 1973 on less the crossmemeber. This floor is the latest shape ever made wich is stronger and has a gusset section down the L/H side to carry extra fuel lines. Also see HMP441004/5 floor sec...

£265.00 exc vat

£318.00 inc vat

now

£225.25 exc vat

£270.30 inc vat
REAR BACK PANEL LOWER HALF MK2 on
HMP441019

genuine rear lower back panel for MK2/3 on, which goes up as far as lower edge of backlight seal ridge

£240.00 exc vat

£288.00 inc vat

now

£216.00 exc vat

£259.20 inc vat
BODYSIDE MK3 N/S FROM A POST BACK
CZH431

bodyside from floor to roof high and includes door frame aperture L/H.

£395.00 exc vat

£474.00 inc vat

now

£335.75 exc vat

£402.90 inc vat
CROSS MEMBER SQUARE TUNNEL FOR ROD CHANGE MINIS ON...
CZH2675

The crossmember holds the seat brackets and has the correct shape on the bottom to sit correctly on the floor of the rod change tunnel only. This is the complete section from inner sill one side to the other. Fits all square type rod change gearbox f...

£56.00 exc vat

£67.20 inc vat