£160.00 exc vat
£192.00 inc vat
In stock
£160.00 exc vat
£192.00 inc vat
In stockRecommended usage 1 x ABD360180 to fit one mini.
This inner wing with A panel and door stiffener check strap panel attached for ease of fitment and alignment.No radiator cooling fin slots or the round hole for electric fans and therefore is only suitable for cars with the front mounted radiator, su...
Metal floor plug as per original with rubber seal.
For use in 1" hole.
The last type of rod change rib design floor made for the assembly line fits cars from 1997-2000. It has a large rib down the centre of the L/H side.
This floor produced from genuine tools has the crossmember fitted with the sill panels an...
Small reinforcement bracket panel between the inner and outer sill on the LH side rear. The 24A43 slinger sits underneath this bracket under the sill panel.
Small reinforcement bracket panel between the inner and outer sill on the RH side rear. The 24A42 slinger sits underneath this bracket under the sill panel.
Small reinforcement bracket panel between the inner and outer sill at the front, these are the same both sides.The 24A41 slinger sits underneath this bracket under the sill panel
O/S/F wing t for 1996 on cars. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replace or renew the stiffener lip ALR360380
Has the headlamp re...
Upgraded L/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
Upgraded R/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
L/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3
this is a genuine heritage part.
R/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3
this is a genuine heritage part.
Small angled bracket fitted by factory to stiffen front wings to A panels
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.
The whole front bulk head assembly with bonnet hinges on the lower dash panel, crossmember and toe board with start of rod change floor tunnel,reinforcements for holding steering rack and heater mounting points --made for vehicles from 1990 on with 1...
If you fit 13" wheels and need to cut the wings away for clearance these are the reinforcements strips Rover used on the cars with Sportspack arches.
see Downloads on web site for diagrams on where to cut wings and A panels under part number...
This rear bulkhead panel is the actual panel the rear passengers back rest against where the upright seat squab is positioned. Not always carried in stock but usually available to special order--this is done to the last factory pressing with the loca...
NON genuine 8"wide outer sill for the van/pick up and estate range with MK3 square pressings. No genuine wide panel is available but see 14A9026/7 for 4" wide panel which actually covers only 2.5" of actual lower floor pan whereas the non genuine pan...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.