£19.20 exc vat
£23.04 inc vat
In stock
£19.20 exc vat
£23.04 inc vat
In stockRecommended usage 2 x MSSB1113GREY to fit one mini.
Static 3 point fixing front seatbelt with the female fixing on a stem.
3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996
<...
3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996.
...
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the pre tensioner types fitted in Europe.
It will arrest the wearer within the same tolerances without a need for a...
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the inertia reel type fitted from 1976 including the later pre tensioner type. Not suitable for MK1/2 saloons and vans/pickups due to...
Bracket on the crossmember that holds the seat.
2 required per seat.
If your vehicle had a seat that locked to the floor it is an MOT requirement that you fit that type of fitting seat back in for safety requirements. This seat frame will allow you to fit the Cobra range of seats to your mini.
See [link]SEAT1...
Seat recliner handle for factory fitted Mk1/2 recliner seats. Also fits some MGB, Sprite and Midgets.
The Cobra Classic is a low back bucket seat designed for fast road use in modified saloons and sportscars. It's deep sides give firm lateral support and the low density foam padding assures a comfortable ride. Vinyl covered seat is 20" at it's widest...
If your vehicle had a seat that locked to the floor it is an MOT requirement that you fit that type of fitting seat back in for safety requirements. This seat frame will allow you to fit the Cobra range of seats to your mini.
See [link]SEAT1...
The clips that hold the seat squab vinyl to the frame on front seats and the headlining. These clips are available seperately as GHF1500.
Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...
Replacement black rear view interior mirror with self adhesive fixing pads. The mirror measures approximately 19.5 x 6.5cm
Interior door pull handle with chrome end pieces, different to the mini but was offered by Rover as a replacement until we showed them the difference.
Originally fitted to MGB and the Austin 1100/1300 range it has 120mm bolt hole centre spac...
The rubber type grip fitted on handbrakes-
will fit any single cable hand brake from 1976 on
Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...
MK1/2 interior door handle with screw and washer.
This solid "spoon" handle is brittle and easily broken.
These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.