Radius arm bearing removal, fitting and reaming tool fitted with a pilot to keep the reamer in line with the needle roller bearing. Full instructions supplied.

This tool bolts where the starter motor fits to lock the flywheel in place when trying to remove the flywheel bolt/crank pulley etc.

1/2" hex key socket needed when using our upgraded crank pulley bolt C-AHT147, 1/2" drive.

CV fitting tool, designed to assist with the correct fitting of CV joints, wheel bearings or drive flanges, as specified in the Haynes workshop manual. The wheel bearing should be torqued to the specified setting using this washer, and then removed a...

Roll pin punch for removing RPS1416 roll pin from the gear selector mechanism.

Multi-Purpose LM2 Grease supplied in a 500G tub.

This grease is suitable for Wheel Bearings, Radius Arms, Upper arms, knuckle joint cups and other regular greasing points.

This new type suspension cone tool for removing or refitting the rubber suspension cone is METRIC thread only and improved by using a hex(allen)key to screw in and hold the centre spindle. There cannot be many cars left out there with the AF type th...

Spanner for adjusting the jet on silver coloured original jets on HS type carbs

short handle to enable use in tight places such as a mini engine bay.

WILL NOT FIT LATEST BRASS TYPE ADJUSTER NUTS AS FITTED TO REPLACEMENT CARBS SINCE ...

This sockket is for A plus flywheel nuts only-so if you have an early type diaphragm clutch use TOOL03

when removing the head for a decoke or changing valves/springs you will require this tool to release the collets holding the valves in place.