complete rebuild kit for Turbo type HIF44 carbs including needle valve and throttle spindle plus disc.With damper clamp ring as fitted to turbo only

Float needle valve for turbos fitted with standard HIF44 carb. Larger bodied valve.

Inlet size is 0.096". See also WZX1090 smaller bodied valve HIF6 MG Turbo

These screws fit all HS type carb butterflies to hold them on the throttle spindle

yellow identification spring which is heavier than AUD4355 and is an optional extra. For HIF carbs only.

Paper gasket for the float bowl of any HS2/HS4/HS6 carbs.

Replace with new camshaft,it's almost too easy to overlook during a rebuild. Camshaft bearings are pressed into the block and thus are usually done by a machine shop. You would not rebuild an engine without replacing the rod bearings, so why not the ...

ACL Race Bearings



ACL Race series bearings are precision manufactured to a wall thickness of ±0.0040mm giving engine builders close control of vertical oil clearance.

What is the purpose of ACL Race series bearings?
...

Special reinforced gasket for injection cars has metal inserts on exhaust ports plus a metal back on the manifold side which makes surface easier to clean when replacing. Often used on Turbo cars when correct gasket is in short supply.


...

Originally marketed by Minispares in the mid 70s so many companies copied them because of their smart looks and ease of fitment. These have been improved by offsetting the arms to help tighten plus stop the arm falling out when they were straight. Ki...