£175.04 exc vat
£210.05 inc vat
Out of stock
£175.04 exc vat
£210.05 inc vat
Out of stock
SPI with dim dip-fuel injection cars. Just the main loom only, does not include the engine harness or rear loom. With factory alarm.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
First of the thin wall looms, fits 998 cars October 1988> from chassis number 396449 on with a brake servo fitted and dim/dip relay on the headlamp flashers. All cars with side repeaters on the wings, 3 clock cluster, pre engaged starter. L/H/D cars ...
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.
This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.
If you want to tune your engine, or you have an engine for which there is no standard distributor available.....the new 123\TUNE is the answer ! By connecting it to a computer, the end-user can easily adapt the 123\TUNE to fulfill even the most deman...
Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...
THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...
the oil seal to fit on 12A1136 distributor housing. Pre A Plus
the earlier housing 2A612 did not have a seal.
Voltage stabiliser for clubman/2-3 clock side pod(smiths) up to 1988. Three terminals/br1303/20.
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...
Minispares design heavy duty STAINLESS STEEL spotlight bracket, for fitting to cars where it mounts on the front panel valance and grille support panel, giving it perfect rigidity so that the power of the lamp was not impaired. Many cheap aftermarket...
Rotor arm for all A series electric distributors when points are not fitted, except for turbo. The distributor cap for this rotor arm is GDC156.
White lens kit 1988 on. If your front indicator lens is held on by screws then this is the kit for your car with the side wing repeater lens also and correct orange bulbs.
If your front lens is held on by the chrome retaining ring as per all...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.