£7.79 exc vat
£9.35 inc vat
In stock
£7.79 exc vat
£9.35 inc vat
In stockRecommended usage 2 x YUE10011 to fit one mini.
Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.
Bluetooth battery charge monitoring system. Compatible with smartphones running IOS, Android or Windows 10. Battery voltage can easily be checked via an app on your smartphone/tablet within bluetooth range.
Step 1
Download...
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
rear stop and tail lamp for early BMc cars with red plastic lens.
Also stocked is a white lens and single filament bulb equivalent for use as reverse light on kits cars and Mokes as CHM13REVERSE.
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.
For modern day petrol, except 1275cc. See 37H8379MS for 1275cc.
After lengthy tests we have found nearly all vac units are not to the originals but with the change of added oxygenates to petrol in the 1980's and then ethanol in ...
Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitting the cars ignition needs to be turned on and o...
Set of 4 ignition leads from the original supplier to Unipart, suitbale for all twin point minis 1997 onwards
Range of distributors with modern day curves specially built,programmed and tested for Mini Spares in UK.
Beware of the cheap China made units that we have tested and currently offered by other vendors that are poorly made with wrong setting...
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
original Lucas type RESIN BASED CONDENSER made for the 45/59D type distributor if you want a quality item rather than the cheaper inferior parts available. Filled with 3m of winding inside as per original Lucas but every copy analysed to date has ...
Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.
Screw for holding PRC1230A to the number plate light body, 1970 onwards.
Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder
Screw for chrome metal number plate lamp on mk3 19790 on - You will have to drill the lens out to take M4 screw.
This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.
INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car
Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.