£4.80 exc vat
£5.76 inc vat
In stock
£4.80 exc vat
£5.76 inc vat
In stockRecommended usage 1 x TAM1918 to fit one mini.
Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.
The smallest pre engaged starter motor available for the A series yet still producing 1.3KW of power! Ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1004EVO for inertia.
Lightweight higher power version of GXE1004 (1.6KW as apposed to 1KW), ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1005RACE for pre engaged.
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
1.0 KW steel gear reduced unit, that draws less current from the battery when starting. Huge increase in comparison to the original units, and are a direct replacement part for the original pre-engaged starter motor.
Not ...
Printed circuit board for 1989 to 1996 3 clock Nippon Seiko type Mini gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
designed for demanding race application and especially high compression motors
where more cranking power can be achieved using much less of the battery power
Brand new Inertia starter with the correct 9 tooth pinion for all minis up to the fitment of the pre engaged type in 1984/5. Do not fit the 10 tooth starter sold by many as it can ruin the ringear or the bendix. Other leyland cars used 10 teeth such ...
universal battery clamp replacement with securing bolts and marked N
Cable for solenoid to inertia starter on Pre-1985 minis or can be used as a long earth cable.
Your battery box 5L877 should be held in place by this rubber strap.
This "Pigtail" wire is all that carries current through the distributor to the points.Fits 23 and 25d type distributors
100% silcone translucent outer sheath, 8mm lead set with stainless steel wire spiral bound wire giving instant and greater resonance, Kevlar fibre core and a ferromagnetic layer for EMC suppression by Luminition. Top end of ignition lead sets.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
Best quality available-there are so many unreliable imports we have gone to Intermotor one of the original suppliers since the demise of original Lucas.
The activation of the starter motor starts with the key (or push button in the early car...
Universal battery clamp replacement with securing bolts and marked P.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.