Showing 1 to 7 of 7

Lower arm cross pin which holds the 2 rubber bushes is also available as an OE spec after market part as 2A4362MS.

See our special bushes for use when you have corrected the geometry on your car. C-STR631 and [link]...

Although you don't think of them as wear items, I have seen the ball joint seats stretch to the point where the ball joint threads were well below the arm which means you cannot tighten the nuts properly . (This happens from repeated over-torquing of...

Ultimate lower arm for road or race. (pair supplied)

One piece, forged, fully adjustable on the car lower arms (with knuckle for bushes) to allow adjustment for any camber setting required. Sold in pairs only. It is recommended that you fit ...

This is the spacer for fitting either side of the spherical joint or rose joints on lowers arms, made to fit all our lower arms with this type of fitment. Sold individually

The original lower arm rubber bush with a metal insert. This fits all arms that

have twin taper lower arms. Only some very early minis have the arm without the taper which takes 2 top hat rubber bushes. Priced and supplied as 1 item but two ...

Pair of adjustable tie rods. See 21A1092 tie bar kit.

When you change the length of the lower control arm to attain the desired degree of camber, the caster also changes. To reset it you must be able to change the length of the ...

Lower suspension arms to give 2.0 extra degrees of negative camber. Stamped with 2.0 Sold in pairs only.


General:See also c-AJJ3360 fully adjustable arms

Negative camber lower arms are specifically forged in different degrees to...

1