Windshield washer fluid original D shape bottle known as 1 pint or 1/2 litre size bottle, for those after originality. This was replaced by the larger bottle to help comply with MOT standards where people complained the bottle was too small to hold ...
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Bracket on the crossmember that holds the seat.
2 required per seat.
Replacement black rear view interior mirror with self adhesive fixing pads. The mirror measures approximately 19.5 x 6.5cm
This cushion was used on the majority of MK.I front seats.It is about 2" thick and has an extra 1" thick piece that can be glued to the front edge to give the seat cover definition and also support for your legs!
Fitted to all saloons of this period. Shaped to the original design but made in modern day specification foam. The cushion is placed over the rear seat frame and the turned ends glued to follow the shape of the frame. The seat cover is then situated ...
This base foam was used on the Saloon models of this period. The main foam has a foam topper on the front edge to give thigh support!! It also gives the front of the seat character.
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Switch panel bracket 1987 onwards to suit later style choke cables.
Ideal for solving the problem of fitting extra speaker's, this speaker board is simple to fit, and well finished speaker holes are oval 6"x9"
Ideal for solving the problem of fitting extra speaker's, this speaker board is simple to fit, and well finished.holes are oval shaped 6"x9"
This bag is made out of "Hardura" which is a heavy PVC with a felt backing laminated to it. When sewn up it will hold the Jack & lever and is all held with the tie Straps. Because the bag is made of heavy material it will not wear through unlike plas...
MODERN TYPE FOAM CUSHION CUT PRECISELY TO SHAPE READY TO RECEIVE NEW SEAT COVER.FOAM IS READY TO ACCEPT NEW SEAT COVER WHICH IS GLUED TO THE TOP SURFACE, THEN THE SEAT SKIRTS ARE TURNED OVER THE EDGES AND AGAIN GLUED IN PLACE. SUGGEST CHEMICAL BASED ...
These wheel arch covers are available in Gold brocade material to match the rest of the trim panels. Mini Cooper 1962-67
This was the first style of sunvisor pad with central pivot point in cream crackle finish used on the early Minis.Some very early minis used pale grey for std but all Supers had crinkle finish cream to match headling. For this period the Cream Crackl...
This chromed bracket is to secure the early Mini sunvisor with the central location.
1959-64 visors had one central hinge and in October 1964-65 they fitted a sunvisor with a hinge one end and clip fixing the other-this is when the first pla...
Moulded carpet set for all Minis EStates built after May 1973. The gear box linkage mechanism was changed the to a rod system which included a redesign of the gear box tunnel in the front floor area. These new sets have truly moulded front and rear s...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.