NGK SPARK PLUG 8 PORT RACE
C9E

($7.50) £7.50 exc vat

($9.00) £9.00 inc vat

In stockIn stock
SMALLER 10MM PLUGS FOR THE ALLOY 8 PORT HEAD THESE ARE GREAT FOR RACE USE

SEE C8E ALSO

($7.50) £7.50 exc vat

($9.00) £9.00 inc vat

In stockIn stock

Recommended usage 4 x C9E to fit one mini.

Alternative products
NGK SPARK PLUG 8 PORT ROAD
C8E

SMALLER 10MM PLUGS FOR THE ALLOY 8 PORT HEAD THESE ARE GREAT FOR ROAD USE

SEE C9E ALSO

($7.13) £7.13 exc vat

($8.56) £8.56 inc vat
People also bought products
NGK SPARK PLUG 998/STD 1275
BP6ES

Slightly hotter running engine plug for A Plus 998 and all 1275cc standard engines. For engine running CR of 9.4 to 10:1

($2.20) £2.20 exc vat

($2.64) £2.64 inc vat
NGK SPARK PLUG 8 PORT ROAD
C8E

SMALLER 10MM PLUGS FOR THE ALLOY 8 PORT HEAD THESE ARE GREAT FOR ROAD USE

SEE C9E ALSO

($7.13) £7.13 exc vat

($8.56) £8.56 inc vat
NGK SPARK PLUG HIGH TUNE RACE
BP9ES

race plug

($3.60) £3.60 exc vat

($4.32) £4.32 inc vat
NGK SPARK PLUGS ALL 850/998 STD TUNE
BP5ES

Standard heat plug for all 850/998cc low compression engines up to 9.4:1 CR.

A plus 998 engines with flat top pistons use BP6ES which run hotter with 88 degree thermostats use BP6ES also.

($2.84) £2.84 exc vat

($3.41) £3.41 inc vat
NGK SPARK PLUG RESISTOR TYPE FOR TWIN POINT BPR6E
BPR6EVG

The spark plug for twin point injection cars to give good ignitability requiring low voltage with resistors to offer protection of the engine management system car radios and telephones.

($2.40) £2.40 exc vat

($2.88) £2.88 inc vat
COIL ORIGINAL SPORTS GOLD PERFORMANCE TYPE
MSC105

Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...

($20.70) £20.70 exc vat

($24.84) £24.84 inc vat
DISTRIBUTOR CSI 43/45D ELECTRONIC NON VAC PERFORMA...
C-27H7713

CSI-Ignition is a fully electronic ignition built in an original housing. You will have to remove the cap to see the difference!neg earth only

After removing the cap you can select between 16 different curves by using

a screwdriver....

($225.00) £225.00 exc vat

($270.00) £270.00 inc vat
ROTOR ARM FOR 25D TYPE PERFORMANCE TYPE
GRA101

If you have an original 25D type distributor this is an upgraded arm (blade moulded and riveted )for performance use because all the other types available now are likely to fail at high revs. Because the blade is thin,or the rivet sometimes to long a...

($12.00) £12.00 exc vat

($14.40) £14.40 inc vat
DISTRIBUTOR CAP SIDE ENTRY FOR 45D TYPE
GDC142

A favourite for specials where room is at a premium and easy access is required for 45D type distributors only--uses GRA2128 rotor arm and obviously discard screws from cap and use existing distributor clips to secure.

some caps...

($8.80) £8.80 exc vat

($10.56) £10.56 inc vat
ROTOR ARM FOR ELECTRONIC DIZZY 1990-96
GRA2143

Rotor arm for all A series electric distributors when points are not fitted, except for turbo. The distributor cap for this rotor arm is GDC156.

($1.80) £1.80 exc vat

($2.16) £2.16 inc vat
DISTRIBUTOR SPINDLE O RING SEAL
513682A

The O ring that actually sits on the distributor drive spindle shaft in the recess provided.

($0.48) £0.48 exc vat

($0.58) £0.58 inc vat
DISTRIBUTOR CAP ELECTRONIC IGNITION
GDC156

This was the first mini distributor cap to have screws hold the cap to the body from about 1990 on, when electonic ignition was introduced. Therefore there is no points or condenser but the rotor arm to use is GRA2143. Fits all 1992 onwa...

($5.45) £5.45 exc vat

($6.54) £6.54 inc vat
CONTACT POINTS FOR 45D 1974-80(RED PLASTIC)
GCS2118

These points were fitted from 1974-80 when the distributors became a 45D type,

the distributor cap shape changed also to GDC136 and likewise rotor arm GRA2114 and condenser GSC2109.

($2.90) £2.90 exc vat

($3.48) £3.48 inc vat
VACUUM PIPE ELBOW
12B2062

The stock vacuum advance distributor is connected to the carb/manifold by a small rubber joint that in turn is mated to metal line that fits the distributor. If the little rubber connector is deteriorated it could allow a vacuum leak at the carb and ...

($2.25) £2.25 exc vat

($2.70) £2.70 inc vat
PERFORMANCE ROTOR ARM - 45D/59D TYPE
GRA2130

The original blue rotor arm was fited with a blue cap GDC143 to the turbos and were made stronger by moulding and riveting the contact plate to the arm, so if you are looking for an upgrade on your 45D body distributor this is our altern...

($9.00) £9.00 exc vat

($10.80) £10.80 inc vat
ROTOR ARM FOR 25D DISTRIBUTOR
GRA2101

See GRA101 for quality rotor arm

Most minis up to 1974 had the 25D type distributor fitted with side or top entry caps. This rotor arm fits both but for any sort of performance use they have failed because the contact blade on the arm is now...

($2.83) £2.83 exc vat

($3.40) £3.40 inc vat
HT LEAD SET RED SILICONE FROM LUMINITION
HV22

100% silicon insulation, silicon coated suppressed conductor,braided glass reinforcement,increased working temperature 0f minus 50C to +300 degrees with improved resistance to damp and water, great fitting and spiral bound wire giving instant and gre...

($29.25) £29.25 exc vat

($35.10) £35.10 inc vat
CONTACT POINTS 25D DISTRIBUTOR PRE '74
GCS2101

Quickfit points for 23 & 25D4 distributors, keep a spare

($3.30) £3.30 exc vat

($3.96) £3.96 inc vat
LEAD SET FOR MPI 1997 on-Genuine
GHT289

Genuine Rover/Unipart 4 high quality silicone plug leads for twin point injection minis. For use with M4 type coil.

($21.82) £21.82 exc vat

($26.18) £26.18 inc vat
DISTRIBUTOR SHIELD BLACK CLIP
13H6461

Each clip kit has 3 parts, clip, spacer and turnbutton. Each kit sold separately and 3 kits per car are required.Now in black to match shield and not show dirt or grease

This is the button with a spade on the end which often breaks, which ho...

($1.75) £1.75 exc vat

($2.10) £2.10 inc vat