REVERSE LIGHT SWITCH WIRING LOOM
GAE191LOOM

($13.73) £13.73 exc vat

($16.48) £16.48 inc vat

In stockIn stock
Wiring loom for rod change reverse light switch.

($13.73) £13.73 exc vat

($16.48) £16.48 inc vat

In stockIn stock

Recommended usage 1 x GAE191LOOM to fit one mini.

Recommended products

Used on Rod change gearboxes and fits on the side of the gearlever alloy housing, the locknut is to prevent the switch being screwed in to far. Use 22A1613 locknut.

People also bought products

All Minis require an earth strap from the engine to the body and from 1959-1996

they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.

Interior lamp with square blunt ends. This part superseded 13H192 which originally had the black on/off switch which BMC also fitted as an alternative. Fitted from October 1964 when courtesy light switches were introduced on Cooper from body number 3...

Single bullet connector used to join the front loom to the rear loom near the wiper motor.

Double bullet connector used to join the front loom to the rear loom enar the wiper motor.

Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...

Special flat 3/8" UNC nut for the reverse light switch GAE191.

Used on Rod change gearboxes and fits on the side of the gearlever alloy housing, the locknut is to prevent the switch being screwed in to far. Use 22A1613 locknut.

Cable for solenoid to inertia starter on Pre-1985 minis or can be used as a long earth cable.

These strange little amber coloured bulbs are used on the front wing side indicators fitted from 1986 on, should be fitted when a clear colour lens is used. The same bulb in white when using amber coloured lens is GLB501. 5 watt 12 volt....