OUTER SILL 8" MK III L/H VAN
MS58L

($36.16) £36.16 exc vat

($43.39) £43.39 inc vat

In stockIn stock
NON genuine 8"wide outer sill for the van/pick up and estate range with MK3 square pressings. No genuine wide panel is available but see 14A9026/7 for 4" wide panel which actually covers only 2.5" of actual lower floor pan whereas the non genuine pan...

($36.16) £36.16 exc vat

($43.39) £43.39 inc vat

In stockIn stock

Recommended usage 1 x MS58L to fit one mini.
Van, Estate and Pick up Floor - Qty 1

Alternative products

outer sill panel for van and estate versions L/H from genuine tooling but we consider it a MK3 floor shape pressing

People also bought products

Non genuine section repair panels equivalent to MS51VAN. This is the left hand side with castellated nut fittings for subframe

For vans with metal load floors and pickups so match up before cutting out to much material

Non genuine section repair panels equivalent to MS51VAN. This is the right hand side with castellated nut fittings for subframe

For vans with metal load floors and pickups so match up before cutting out to much material

Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.

Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28R.

For Mk3 but can be used as a part of repair sectiion for Mk1/2

Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28L.

For Mk3 but can be used as a part of repair sectiion for Mk1/2

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

Part inner wing L/H from Damper bracket mounting points forward. MK1/2/3 except Clubman. This panel has radiator cooling slats as fitted to 1991

NON genuine panel only as part panel

Non genuine L/H repair section

for wind up window type doors this is the lower 2-3" of the inner skin and the bottom of the door section that usually rusts out-includes a lip section where the outer skin flaps overlaps for fitment--new panel...

2-3" lower section of body section

from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge type doors.

Aftermarket version of the L/H floorpan for 1991 on cars.

This floor was made stronger with smaller heel pad area to prevent vibration and rust and will fit any Rod change gear shift mini but was introduced on the first injection cars in 199...

A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.

Experience has shown its easier to fit the genuine panel HMP441001 al...

non genuine oversill MK1/2 van floor profile R/H with 4 flute vents

see MS58R for 6 flute type side, wide type

2-3" lower section of Van body section

from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge tye doors

THIS NON GENUINE PANEL PROTECTS THE UNDERSIDE OF THE WINDSCREEN VALANCE UNDER THE FRONT WING SECTION RIGHT HAND. Also fitted on the inner wing panel 14A8346 & 14A8347.

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...

genuine rear lower back panel for MK2/3 on, which goes up as far as lower edge of backlight seal ridge