STARTER SAFETY PANEL PUSH BUTTON WITH 3 SWITCHES
MSA344-3

($43.52) £43.52 exc vat

($52.22) £52.22 inc vat

In stockIn stock
On /Off safety swith guard and press starter switch,plus three switches

($43.52) £43.52 exc vat

($52.22) £52.22 inc vat

In stockIn stock

Recommended usage 1 x MSA344-3 to fit one mini.

People also bought products

Repair loom and plug for all post 1976 headlamp switches.See PM08 for headlamp switch with plug and correct wires colours for loom repair

Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...

With an integral push start button built in the solenoid as originally fitted to early minis. The activation of the starter motor starts with the key (or push button in the early cars), but the most important function is carried out by the solenoid....

Special flat 3/8" UNC nut for the reverse light switch GAE191.

On /Off safety swith guard and press starter switch,a red and green safety light plus one switch, no wiring included. Plate size 65mm x 135mm.

On /Off safety swith guard and press starter switch,a red safety light --See MSA337 for extra swith and light, no wiring included.

If you have a floor mounted type of headlamp dip switch then this is the item you require.Mk1 Mini--sprite/midget MGB67-70,morris Minor.landrover,bentley, rolls and many more.

IGNITION BARREL TO FIT 13H337 SWITCH. MK1/2/EARLY MK3. ONE BARREL,TWO KEYS

circuit breaker for safety as required in motorsport

The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...

Brake light switch for pre 1976 minis with single line brake systems. Fits into banjo bolt (7H7995) located at O/S front brake hose. This switch has a tapered thread. Made by a UK company who suplied parts to Unipart.

For minis ...

MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.

For barrel only use part number 24G1345.

Headlamp switch fits MK1/2/ earlyY MK3, Toggle type also known as bat handle type, 3 POSITION. BLADE CONNECTIONS.

Battery cut-off switch. FIA approved

Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...

This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.

These used to be supplied with a little bracket but it was discontinued by the factory so it now just hangs loose under the dash. But Minispares have re-introduced it as 5L433

RELAY FOR STARTER, sometimes green, mainly black ...The relays for the electrics appeared from about 1985 and on all injection cars and are colour coded for ease - number YWB000430 stamped on part is different from part number.

30 amp 5 spad...

HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.