NEEDLE VALVE SEAT MG TURBO
WZX1090

($22.34) £22.34 exc vat

($26.81) £26.81 inc vat

In stockIn stock
Needle valve and seat for turbo HIF6 carb.

Small body valve but has larger hole(0.125") for high boost engines.

Can be fitted to HS2/4/6.

($22.34) £22.34 exc vat

($26.81) £26.81 inc vat

In stockIn stock

Recommended usage 1 x WZX1090 to fit one mini.

People also bought products

complete rebuild kit for Turbo type HIF44 carbs including needle valve and throttle spindle plus disc.With damper clamp ring as fitted to turbo only

Fuel or water T piece adaptor

used when upgrading fuel system size on specials from 1/4" to 5/16" or any other modifications

Float needle valve for turbos fitted with standard HIF44 carb. Larger bodied valve.

Inlet size is 0.096". See also WZX1090 smaller bodied valve HIF6 MG Turbo

Swinging type needle, usefull for 256 degree duration camshaft with standard filter, see BDK NZX8010 for K&N filter.

Standard spring for all HS2 and HS4 on minis except for the 997/998 Cooper from 1964-9 and H4 special tuning carbs which used AUC4587.

These screws fit all HS type carb butterflies to hold them on the throttle spindle

Used in petrol fuel lines to take 1/4" petrol hoses it is used mainly on twin carb set ups for petrol being diverted to the 2 carbs.

yellow identification spring which is heavier than AUD4355 and is an optional extra. For HIF carbs only.

The proper slot head screw for the SU dashpot and float lid 3/16 whitworth thread.

Paper gasket for the float bowl of any HS2/HS4/HS6 carbs.

The correct one for the origianl HIF44 carbs fitted to 1990-92 1275cc Coopers

Replace with new camshaft,it's almost too easy to overlook during a rebuild. Camshaft bearings are pressed into the block and thus are usually done by a machine shop. You would not rebuild an engine without replacing the rod bearings, so why not the ...

ACL Race Bearings



ACL Race series bearings are precision manufactured to a wall thickness of ±0.0040mm giving engine builders close control of vertical oil clearance.

What is the purpose of ACL Race series bearings?
...

ACL Race Bearings



ACL Race series bearings are precision manufactured to a wall thickness of ±0.0040mm giving engine builders close control of vertical oil clearance.

What is the purpose of ACL Race series bearings?
...

Adjustable engine upper stabiliser rod.

Copy of ERA 1020 adjustable rod as fitted to the ERA mini turbo for clearance reasons. This adjustable rod takes the standard rubber bushes or equivalent and is a useful means of pushing the top of the...

Special reinforced gasket for injection cars has metal inserts on exhaust ports plus a metal back on the manifold side which makes surface easier to clean when replacing. Often used on Turbo cars when correct gasket is in short supply.


...

Steel centre main strap for large bore engines, comes with longer high tensile bolts. Main top cap needs machining flat, no other modifications required.

On all performance A series engines it is essential to ensure accurate and as near perm...

Originally marketed by Minispares in the mid 70s so many companies copied them because of their smart looks and ease of fitment. These have been improved by offsetting the arms to help tighten plus stop the arm falling out when they were straight. Ki...

Made especially for turbos to stop leakage and heat problems this gasket has metal ring retainer inserts on the exhaust ports. Sold singularly.