Secondhand (used unit)only. This sits under the 28G251(DAM8488) alloy housing where the speedo cable connects to on the gearbox and the speedo drive pinion slots through this.Obsolete from Rover we are offering these old used units in ca...

Left hand differential lock tab as used on rod change boxes up until 1982 when they were not longer used. For R/H locktab see 22A962

Solid dowel at the front of the engine that locates the block to gearbox.

This is the spring for the anti sizzle gearstick fitted to cars with remote gearboxes from 1964-1973.



Fits under the metal cup 22G290 and provides tension to the 22G292 plastic collar that presses onto the gearlever.

Bolt that holds elector fok to change rod on Pre A plus gearboxes.

both remote and magic wand type

Single roller bearing that only fits 3 synchro gearboxes to hold the 1st motion shaft-sporadic stocks only of these bearings as they went obsolete in 2008. These are genuine RHP/NSK bearings

THIS BEARING HAS PRE A+ INNER DIAMETER AND A+ OUTER DIAMETER. If you have the large A plus idler gear bearing hole and want to use it for the earlier pre A plus small hole type idler gear then this bearing is what you require to sleeve it down in siz...

The shims go against the mainshaft double roller bearing securing cap in your gearbox to give it pre load. See workshop manual for advice but you are aiming for only 1 thou pre load.

Idler gear shims for the Pre A Plus gearboxes with 0.750" (19mm) size shafts

Quantity required per gearbox is 2 but idler gear shims require shimming for correct clearance 3-6 thou as per workshop manuals but 3 thou for road and 4 thou for r...

This is the standard DAM6624 differentail planet gear but with a special bush inserted in the middle to run on our upgraded diff pin C-BTA166, which alleviates all the play and makes a smoother precision surface for longevit...