(45,00 €) £45.00 exc vat
(54,00 €) £54.00 inc vat
In stock
Beware of cheap China made units that are poorly made- see note at bottom. GEU930 25D 850/early 998
12G2140 23D Cooper S non vac
BAU1962 45D 998/1098
ADU5789 59D 998 A plus
12G4180 45D 1275cc with vac, good for modified road tune engines
ADU3825 59D 1275 with vac, A Plus good for modified road tune
For electronic versions add suffix MS- example= ADU5789MSPre A plus-Distributors stecially designed to run on modern day fuels that have extra oxygenates (added pre 1990's) and current 2015 ethanol levels.
For best performance and tune we advise our electronic evolution version C-27H7698 which is UK made and the best available.
These non electric are priced to save rebuilds or vac units that no longer give correct ignition timing and best acheivable fuel consumption.
These replace 41824A and 41418 plus any 998/1098cc up to the changeover of A plus type distributors
These new units are PRE A PLUS.The originals were made for 998/1098cc even allegro and Maxi 1500/1750cc from 1974 to 1977 and they work fine on any other year 998/1098cc minis also. For 1275cc even with mild engine tune see 12G4180 or for electronic version for neg earth only 12G4180MS or favourite C-27H7698
DODGY DISTRIBUTORS -made in china available from some vendors
We’ve seen distributors with all different curves in the same batch. Base plates
that stick and alter the curves, sometimes jamming in full advance. When tested
we had difficulty getting them to run correctly when using a timing light and we
found that the rotor arm and dog at the bottom of shaft was often out of phase
putting the rotor arm in wrong position in relation to the point at where the spark
fired. We also found rotor arms that were hard up against the carbon bush in the
top of distributor cap causing the cap to burn away in middle.
Having tried and tested countless suppliers of imported and British made
distributors we had all ours individually built and tested to prevent costly engine
failures and breakdowns for the following reason - those suppliers were unable
to advise what curves were in them - we rarely found them the same in any
batch! Every part, even so-called ‘Mini Spares branded parts’ are being copied
for financial gain as Minis climb in popularity and value. Unscrupulous
companies can get parts made cheaply overseas, but they lack the technical
knowledge and precision required to make them correctly
(45,00 €) £45.00 exc vat
(54,00 €) £54.00 inc vat
In stockRecommended usage 1 x BAU1962 to fit one mini.
NEGATIVE EARTH ONLY..45D electronic(contactless)Pre A plus distributor .
replaces 41824A and 41418 plus any 998/1098cc up to the changeover of A plus type distributors. For best performance and tune we advise our electronic evolution versio...
Pre A Plus Electronic Ignition distributor with vac unit, modified to our specification in the UK to give best performance on any minis with std to 276 camshaft profile.
Brand New distributor complete with electronic conversion already fitt...
Sports coil for ballast resistor type ignition.
Best internal parts tested and another intermotor top product.
Its not the name on the outside but whats on the inside which matters.
Original type coil bracket 12G29...
Pre A Plus Electronic Ignition distributor with vac unit, modified to our specification in the UK to give best performance on any minis with std to 276 camshaft profile.
Brand New distributor complete with electronic conversion already fitt...
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.
For those very early 25D type distributors.Mini Spares version for modern fuels as fitted to our distributor range with slide on vaccum hose inlet pipe-not the very first screw in type
For modern day petrol, except 1275cc. See 37H8379MS for 1275cc.
After lengthy tests we have found nearly all vac units are not to the originals but with the change of added oxygenates to petrol in the 1980's and then ethanol in ...
Set of 4 ignition leads from the original supplier to Unipart, suitable for all twin point minis 1997 onwards. For use with M4 type coil.
Negative earth only-45D electronic distributor with vac for 1275GT and any pre A Plus 1300cc engine including Sprite and Midget in line engines-
For best performance and tune we advise our electronic Evolution version C-27H7698<...
Negative earth A Plus 59D for any 1275cc with vac unit with modern day driving curves and petrol avaiable.
For best performance and tune we advise our electronic evolution version C-27H7701
Distributors can 'work' lon...
Range of distributors with modern day curves specially built,programmed and tested for Mini Spares in UK.
Beware of the cheap China made units that we have tested and currently offered by other vendors that are poorly made with wrong setting...
original Lucas type RESIN BASED CONDENSER made for the 45/59D type distributor if you want a quality item rather than the cheaper inferior parts available. Filled with 3m of winding inside as per original Lucas but every copy analysed to date has ...
NEGATIVE EARTH ONLY..Reproduction CONTACTLESS Distributor suitable for modern day fuels for 850 and 998cc pre 1974 with upgraded rotor arm "Negative earth only". A worn out distributor can cost you both performance and economy. Precise spark timing ...
Electronic Distributor for any standard A+ 998cc. Negative earth only.
From 1982on 998cc were fitted with a ballast coil which means a new wire must be fitted from fusebox top left terminal where there is a large white cable to the...
NEGATIVE EARTH ONLY..45D electronic(contactless)Pre A plus distributor .
replaces 41824A and 41418 plus any 998/1098cc up to the changeover of A plus type distributors. For best performance and tune we advise our electronic evolution versio...
NEGATIVE EARTH ONLY. Cooper"S" 23D distributor, no vac unit-This is NOT THE ORIGINAL LUCAS ITEM but a new contact less electric copy of 40819 to cope better with modern day fuels. Fitted with the better Red rotor arm upgrade.Cheaper than many electro...
Coil bracket fitted to end stud of cylinder head,clutch end for coil to mount on as fitted 1969-94-MK3 on. This has been made to the original specification with the welded lug nuts rather than the cheaper method of having just plain holes to take a b...
Screw for holding PRC1230A to the number plate light body, 1970 onwards.
Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...
Originally fitted as standard to the MGB and MGB GT, but has the same plug configuration as the 76 on Mini's so can be used in place of the stabdard rocker switch
If you also have an issue with the plug, a new plug and wiring repair is avail...
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.