(326,42 €) £326.42 exc vat
(391,70 €) £391.70 inc vat
In stock
(326,42 €) £326.42 exc vat
(391,70 €) £391.70 inc vat
In stockRecommended usage 1 x C-STR336 to fit one mini.
The intake/exhaust manifold should be secured to the head with brass nuts and these very thick washers. These washers are intended to not only spread the clamping action but the thickness allows them to absorb the heat without deforming! Takes 4 per ...
Manifold gasket fitted to all A series pre 1992 except Turbo which had a reinforced exhaust ports GUG704063MG and SPI from 199. From 1991 on a new better gasket with reinforced exhaust ports and backing was fitted GUG704053MG
1 inch X 50 feet / 25mm x 15metres
For Race Use only!
Stainless steel Standard bore LCB (1-3/4"id) that is ideal for very hot small bore engines, for standard to high performance 1275s, and for street 1380s. And in stainless steel for long life!
There is NOT enough clearance room when fitti...
7" long steel intake manifold by Maniflow for Weber 45 DCOE/DHLA
Genuine mini Spares inlet manifold dyno tested and designed for our Stage one kit C-STN17. The single SU manifolds is developed to give maximum airflow and gas speed, yet fit all engines even if the standard air cleaner set-up is used. I...
Cast alloy type, Fits either twin HS4 or HS6.(requires modifacation to fit HS6.2 extra studs per carb)
This intake manifold for twin SUs has been carefully produced to minimize cross-port-flow interference caused by t...
The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992. When the RC40 or similar systems are fitted, 2 will be required. This is a stronger poly version.
Competition 2" RCM reverse cone megaphone and front pipe only. For rear box see C-ARA351
2" bore twin box exhaust system. Rear side exit in the standard position. If the 1.75" bore of the RC-40 isn't enough and you want to make it better, and louder, this 2" Maniflow system is for you. Very high quality, with skid plate on the bottom of ...
The popular RC-40 exhaust system was updated to the millennium rangefor the year 2000. All retain the optimum size 1.75" tubing for maximum performance and efficiency, but we now offer a choice of tailpipe size and configuration. This is standard bor...
The popular RC-40 exhaust system was updated to the Millennium range in 2000. All retain the optimum size 1.75" tubing for maximum performance and efficiency, but we now offer a choice of tailpipe size and configuration. Front pipes come either "str...
This Maniflow exhaust system has the qualities you want: warm mellow sound, great looking center exit, 2" chrome plated tail pipe, and it bolts directly to the large bore LCB or 3-1 header.
The popular RC-40 exhaust system was updated to the millennium range for the year 2000. All retain the optimum size 1.75" tubing for maximum performance and efficiency, but we now offer a choice of tailpipe size and configuration. This is 2.25" large...
The popular RC-40 exhaust system has been updated for the year 2000. All retain the optimum size 1.75" tubing for maximum performance and efficiency, but we now offer a choice of tailpipe size and configuration. This one is the centre exit 2" outlet ...
Larger, stronger rear exhaust mounting as used by works cars will usually fit earlier subframes on existing holes in either the middle or side exit position.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.