(69,00 €) £69.00 exc vat
(82,80 €) £82.80 inc vat
(69,00 €) £69.00 exc vat
(82,80 €) £82.80 inc vat
Recommended usage 1 x CCC111 to fit one mini.
The bracket fitted to the boot board and is not in any kits.
When a boot board is fitted the following brackets are required
14A9780x2 U shaped for the rear to hold the board
14A9781x2 side bracket with plug for board to si...
L/H BOOT BOARD BRACKET FOR 7.5 GALLON TANK AND 165 TYRES.
L/H BOOT BOARD SIDE BRACKET FOR 7.5 GALLON TANK.
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
This kit contains all the brackets and mounts that were fitted on to the floor on original Coopers, Wolseley Hornet and Riley Elf with boot boards fitted as standard.
This kit does not include the bracket on the boot board 14A9783
If you have twin original 5.5 gallon tanks this 26" wide boot board is the one for you.
Fits injection cars it is identified as it has 2 corner cut outs to fit. Covered in black carpet.
This is Rovers tailor made plastic boot liner which fits all cars with the larger 7.5 gallon petrol tank fitted from about 1974 on. Fits over the spare
wheel giving a very sturdy load floor with a recess for polish or small tools etc. If thi...
Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...
White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...
Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...
Similar to those fitted as standard on the late Coopers this piece of trimming is purely cosmetic although it may help to eradicate some road noise that might get past the standard rubber gaiter--This is black with red stitching.
Black sun visor less mirror that requires clips both ends but never a standard fitment colour fits cars from Dec 1965. Available as a sought after alternative to the cream colour. The brackets are available as a car set only(4 clips) as SV20...
Ideal for solving the problem of fitting extra speaker's, this speaker board is simple to fit, and well finished speaker holes are oval 6"x9"
The rubber type grip fitted on handbrakes-
will fit any single cable hand brake from 1976 on
Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...
Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.
Also suitable for Twin Point indicator fixings.
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
The metal retainer that holds the rod change gear lever gaiter CZH4278 in place
Original Autin emblem stick on logo for use on gearlever knobs and key fobs sold by us. About 27.4mm wide.