(52,80 €) £52.80 exc vat
(63,36 €) £63.36 inc vat
In stock
(52,80 €) £52.80 exc vat
(63,36 €) £63.36 inc vat
In stockRecommended usage 2 x CS815 to fit one mini.
A complete kit of coil springs and shocks to replace the old suspension rubber cones and trumpets. This is an adjustable set up for standard height cars with full fitting instructions. This kit really does transform a mini suspension and has been saf...
this kit is the 2 coil springs,plus the left and right shock absorbers for rear standard height suspension
New Evolution design in 4mm thick metal mase to fit Genuine and our non genuine subframes better than the standard originals.
The amount a wheel leans in or out at the top is called "camber". As the car turns and the body leans the tire can ...
Angled grease nipple for the upper arm on the front suspension of all Minis
importantly lubricates the upper arm spindle which so often gets neglected so check yours out and make sure this nipple is working properly. Also fits rear radius ar...
Complete rebuild kit for rear radius arm as sold by us since 2005.
Beware of cheap imports that are available in the market as they do not have correct heat treatment where required and have no longevity.
Kit Includes: shaft, beari...
A must-when the castor and camber angles are changed or whenever the geometry of the car is set up you will require these bushes. They are good for cars with up to 3.5 degrees of castor angle.
From November 2003 they have been made from a s...
A single coil spring for the front lowered coil spring type dampers only.
For coil spring performance suspensions only this is the rear left hand damper for standard height suspension only
Always check these grease nipples on your front hubs are working as they are very important. These two swivel pin grease nipples are the same, upper and lower. Also used on the rear radius arms. Sold individually.
these are top quality greas...
For coil spring performance suspensions only this is the rear right hand damper for standard height suspension only
The inner seal for the front hub uses a white plastic protection shield. The outer seal is GHS101. Sold individually.
The correct screw for holding the 2A4267MS bump stop for the upper arm on the front suspension. 3/16"unf 1/2"long flat head phillips type screw.
Rear hub nuts on the mini are sided as the threads are different. This is for the LEFT hand rear. This has a left handed thread.
See NL611041 for the right hand nut.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.