(168,33 €) £168.33 exc vat
(202,00 €) £202.00 inc vat
Out of stock
(168,33 €) £168.33 exc vat
(202,00 €) £202.00 inc vat
Out of stock
The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)
Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...
Late type swith carrier with 4 square holes plus heater and choke cable holes-uses the ratchet type choke cable with D shape fitting--earlier cars used round hole for pull and push chooke cableCZH3591
Mk1 style alloy gear knob. Will suit any Mini standatd gear lever thread.
3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996
<...
Plain white with white backing aftermarket sun visor as fitted to Mk3 models 1977-92 which were thinner than Mk1 for safety crushing requirements. Although not standard for earlier models will fit cars from December 1965. Check out the special clips ...
Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow
number 1 with red ends is EEB100060
number 2 and 3 is white ends are both EEB100070
number 4 with black ends is EEB100080
...
Similar to those fitted as standard on the late Coopers this piece of trimming is purely cosmetic although it may help to eradicate some road noise that might get past the standard rubber gaiter--This is black with red stitching.
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Replacement black rear view interior mirror with self adhesive fixing pads. The mirror measures approximately 19.5 x 6.5cm
MK1/2 interior door handle with screw and washer.
This solid "spoon" handle is brittle and easily broken.
These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...
The black plastic door pocket as fitted to mini metro and minis on wind up window type doors.
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
This is the chrome screw that fits the 14A8151 catch boss on sliding window minis. Also fits the door winder handle on early wind up window cars.
With headrest-this fixed back traditional bucket seat is the entry level
version of Cobra seats and has dep sides and a low back to ensure comfort and support without the restrictions of a larger seat. Black vinyl and no piping-
Fixed back for fast road this is Cobras New Clubman seat which still represents
good value with its massive leap in quality and design. Integral headpad and shoulder supports,deep sided bucketed supports,integral lumber support and four poin...
If your vehicle had a seat that locked to the floor it is an MOT requirement that you fit that type of fitting seat back in for safety requirements. This seat frame will allow you to fit the Cobra range of seats to your mini.
See [link]SEAT1...
Required to fit Mountney wheels to your Mini. The Mkl adapter Black boss has a built-in horn-push. The Mkll (BOSS/V3) is for cars with the horn on the stalk.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.