(7,70 €) £7.70 exc vat
(9,24 €) £9.24 inc vat
Out of stock
(7,70 €) £7.70 exc vat
(9,24 €) £9.24 inc vat
Out of stock
Headlining kit for MPI cars, this is grey cloth as apposed to vinyl (much nicer in our opinion). Rear C post panels included.
Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...
White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...
Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...
Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow
number 1 with red ends is EEB100060
number 2 and 3 is white ends are both EEB100070
number 4 with black ends is EEB100080
...
Similar to those fitted as standard on the late Coopers this piece of trimming is purely cosmetic although it may help to eradicate some road noise that might get past the standard rubber gaiter--This is black with red stitching.
Vinyl handbarke lever cover with internal tie clip at lever end and on the floor end has a locating tag. A good preformed shape as fitted to MPI--the last few available and CK989 will have to be used
Black sun visor less mirror that requires clips both ends but never a standard fitment colour fits cars from Dec 1965. Available as a sought after alternative to the cream colour. The brackets are available as a car set only(4 clips) as SV20...
Ideal for solving the problem of fitting extra speaker's, this speaker board is simple to fit, and well finished speaker holes are oval 6"x9"
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
The rubber type grip fitted on handbrakes-
will fit any single cable hand brake from 1976 on
Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...
Bracket, mk2 switch panel, LH. Locates swith panel to lower dash rail when ALA6621 is fitted. 1967-1987.
Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.
Also suitable for Twin Point indicator fixings.
Metal plate switch carrier for 5 square type switches.
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
The metal retainer that holds the rod change gear lever gaiter CZH4278 in place
Original Autin emblem stick on logo for use on gearlever knobs and key fobs sold by us. About 27.4mm wide.
Original BMC stick on logo for use on gearlever knobs and key fobs sold by us.
about 27.4mm wide
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.